Selection of Participants The principal investigators at OSU were to pilot test the survey instruments with professional contacts in parks and recreation that manage pedestrian trails...
Search Results "Pedestrian Route"
Filters
Commonly Searched Documents
-
Selection of Participants
-
4.7.10 DIAGONAL CURB RAMPS
If diagonal (or corner type) curb ramps have returned curbs or other well-defined edges, such edges shall be parallel to the direction of pedestrian flow....
-
1.1.8 Alternate measurement tools
If the F - number system is used pedestrian paths should have a minimum FF of 25. Running slope should be measured along the same lines of measurements as given in Section 1.1.3....
-
1.1.7 Measurement of parking areas
These areas should be considered as a pedestrian walk with a minimum width of 60 in. and a length of approximately 20 ft and with an ADA/ABA - AG maximum slope of 1:48 in both directions...
-
General: ADA Standard Section 234.1
Section 234.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for amusement rides.
-
11B-234.3 Minimum number
These rides are not exempt from the other provisions in Section 11B-234 requiring an accessible route to the load and unload areas and to the ride....
-
11B-210.1 General
In alterations, stairs between levels that are connected by an accessible route shall not be required to comply with Section 11B-504, except that striping complying with Section 11B-504.4.1...
-
403 Walking Surfaces
Requirements in 403 for walking surfaces apply to portions of accessible routes existing between doors and doorways, ramps, elevators, or lifts....
-
11B-405.7 Landings
Curvilinear ramps with small radii also can create compound cross slopes and cannot, by their nature, meet the requirements for accessible routes....
-
12143(c)(1)(A)(ii)
able with such assistance) to board, ride, and disembark from any vehicle which is readily accessible to and usable by individuals with disabilities if the individual wants to travel on a route...
-
10.3.1(13)
(13) Where it is necessary to cross tracks to reach boarding platforms, the route surface shall be level and flush with the rail top at the outer edge and between rails, except for a maximum...
-
4.1.6(1)(b)
If the applicable provision for new construction requires that an element, space, or common area be on an accessible route, the altered element, space, or common area is not required to...
-
§ 37.123(e)(2)
able, with such assistance, to board, ride and disembark from any vehicle which is readily accessible to and usable by individuals with disabilities if the individual wants to travel on a route...
-
F221.4 Designated Aisle Seats
At least 5 percent of the total number of aisle seats provided shall comply with 802.4 and shall be the aisle seats located closest to accessible routes....
-
221.4 Designated Aisle Seats
At least 5 percent of the total number of aisle seats provided shall comply with 802.4 and shall be the aisle seats located closest to accessible routes....
-
Regulatory Flexibility Act
There are not significant cost impacts on fixed route service at all, and the number of small grantees who operate fixed route systems is not large....
-
Abstract
Individuals with disabilities have the same desire to explore nature and physical barriers such as inaccessible surfaces and routes can hamper or even prevent opportunities to participate...
-
§ 36.403(g)(2)(ii)
(ii) An accessible route to the altered area;...
-
Sec.36.403(g)(2)(ii)
(ii) An accessible route to the altered area;...
-
11B-240.1.1 Additions
When the first phase was completed, at least 5 elevated play components, including at least 3 different types, were to be provided on an accessible route....
-
240.1.1 Additions
When the first phase was completed, at least 5 elevated play components, including at least 3 different types, were to be provided on an accessible route....
-
11B-240.1.1 Additions
When the first phase was completed, at least 5 elevated play components, including at least 3 different types, were to be provided on an accessible route....
-
11B-240.1.1 Additions
When the first phase was completed, at least 5 elevated play components, including at least 3 different types, were to be provided on an accessible route....
-
[2010 ADAS] 105.2.3 ASTM
The play areas requirements in this document reference the ASTM F 1487 standard when defining accessible routes that overlap use zones requiring fall attenuating surfaces....