Flush controls shall be hand operated or automatic....
Search Results "Operation (Elevator)"
Commonly Searched Documents
-
11B-604.9.5 Flush controls
-
3001.1 Scope
This chapter governs the design, construction, installation, alteration and repair of elevators and conveying systems and their components....
-
11B-404.1 General
Exceptions: Doors, doorways, and gates designed to be operated only by security personnel shall not be required to comply with Sections 11B-404.2.7, 11B-404.2.8, 11B-404.2.9, 11B-404.3.2...
-
NAADAC Webinar Series: "ADA: The Next Generation" - Virtual and At-Home Training
This unique and important series of seven webinars brings together some of the country’s most experienced ADA experts and trainers, combining the “official” view with practical...
-
Scoping [4.1.3(5)]
In new construction, platform lifts can be used instead of ramps or elevators only in providing access to: performing areas in assembly occupancies wheelchair seating locations...
-
Height Above Finish Floor or Ground: ADA Standard Section 703.4.1
EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1....
-
CIRCULATION PATH
[DSA-AC] An exterior or interior way of passage provided for pedestrian travel, including but not limited to, walks, sidewalks, hallways, courtyards, elevators, platform lifts, ramps, stairways...
-
What Contributes to the Determination of "Readily Achievable"?
Legitimate safety requirements that are necessary for safe operation VI. Impact otherwise on the operation of the site VII....
-
Cross Slope
In other words, cross slope is the difference in elevation from the inner edge to the outer edge of a trail, outdoor recreation access route, or beach access route....
-
13. Do the provisions for openings in floor and ground surfaces in Section 302.3 apply to walking surfaces in play areas?
Section 302.3 applies to accessible routes that connect to ground level play components and that provide ramp access to elevated play components....
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
1.1.12 Ramp cross slope
Measure for overall cross slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations...
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
11B-203.5 Machinery spaces
Machinery spaces include, but are not limited to, elevator pits or elevator penthouses; mechanical, electrical or communications equipment rooms; piping or equipment catwalks; water or sewage...
- Brewer 3000 LiftMate Low / High Patient Lift
- Pilot Rock FSW-30 Campfire Ring
- Lift Disability Network
-
R302.2 Components
Elevators and limited use/limited application elevators complying with sections 407 or 408 of Appendix D to 36 CFR part 1191; 7....
-
USE OF THE WAY
The only standard building egress system that may require the ability to speak in order to evacuate a building is an emergency phone in an elevator....
-
Running Slope
In other words, the slope is the difference in elevation from the beginning to the end of a part of a trail, outdoor recreation access route, or beach access route, measured in the direction...
-
Transits and construction lasers
Transits and construction lasers are useful for setting or measuring overall elevation points to determine a total slope....
-
11B-106.5 Defined terms
PLAY COMPONENT ELEVATOR, PASSENGER EMPLOYEE WORK AREA ENFORCING AGENCY ENTRANCE EQUIVALENT FACILITATION EXISTING BUILDING OR FACILITY EXIT FACILITY FUNCTIONAL...
-
Employee Work Areas: ADA Standard Section 206.2.8
Section 206.2.8 covers scoping requirements in the most current ADA Standards for accessible routes in employee work areas.