Curbs adjacent to such spaces must be of a height that does not interfere with the opening and closing of motor vehicle doors. Figure 502.2 Vehicle Parking Spaces...
Search Results "Door Opening Force"
Filters
Commonly Searched Documents
-
502.2.1 On-street parallel parking
-
Rockwood Manufacturing Company 620 UL Listed 160˚ Door Viewer For Doors 1-3/8" to 2"
For Doors: 1-3/8" to 2" Weight: 0.1 lbs. ANSI A156.16: L03222, L03172 Most of Rockwood's products are available in a wide variety of architectural finishes....
-
11B-809.10.7.5 Controls
The force required to activate controls shall be 5 pounds (22.2 mm) maximum....
-
NYC Board of Elections: Video 6 - Verifying Temporary Solutions
-
1133B.2.5.1
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.5.1 Door closer. ...
-
e-vi
Are signs mounted on both sides of the elevator hoist way door opening (for each elevator and at each floor) that designate the floor with 2-inch minimum-height raised letters and Braille...
-
604.7 Open Type Toilet Paper Dispenser Height
-
Structural Strength: ADA Standard Section 610.4
Section 610.4 covers the current ADA Standards for the structural strength of seats.
-
Structural Strength: ADA Standard Section 903.6
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
11B-610.4 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Structural Strength: ADA Standard Section 609.8
Section 609.8 covers the current ADA Standards for the structural strength of grab bars.
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device,...
-
11B-407.4.10.3 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the support rail, fastener, mounting device...
-
What is an accessibility evaluation survey and when is one needed?
This is measured when the door is open 90 degrees for swinging doors and fully opened for other door types....
-
1010.1.9.7 Delayed egress locks
A sign shall be provided on the door and shall be located above and within 12 inches (305 mm) of the door exit hardware: 6.1....
-
11B-302.1 General
A stable surface is one that remains unchanged by contaminants or applied force, so that when the contaminant or force is removed, the surface returns to its original condition....
-
Hall Lanterns [4.10.4]
(Note that in-car lanterns increase door opening time since timing begins after doors open wide enough for the lantern to be visible)....
-
Door King Inc. 1812 Access Plus Communication System
The 1812 Access Plus controls a main door or gate and can easily be expanded to control up to six additional access points....
-
The Market of Travelers Who Benefit from Accessibility
Doors Organization (ODO), a Chicago non-profit organization, more than 21 million adults with disabilities traveled at least once in the preceding two years. (3) More than 50% of adults...
-
Rockwood Manufacturing Company 619 UL Listed 160˚ Door Viewer For Doors 11/16" to 1-1/16"
For Doors: 11/16" to 1-1/16" Weight: 0.05 lbs. ANSI A156.16: L03222, L03172 Most of Rockwood's products are available in a wide variety of architectural finishes....
-
7(2)(b)
(b) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Clear floor space beside tub may overlap with clear floor...
-
11B-403.5.1 Clear width
The clear width for accessible routes to accessible toilet compartments shall be 44 inches (1118 mm) except for door-opening widths and door swings....
-
611.4 Height
Top loading machines shall have the door to the laundry compartment located 36 inches (915 mm) maximum above the finish floor....
