Several commenters called for the 27 inch triggering height to be reduced. Recommendations ranged from 15 to 6 inches....
Search Results "Character Height (Raised)"
Filters
Commonly Searched Documents
-
307 Protruding Objects
-
810.5.3 Platform and Vehicle Floor Coordination
The height and position of a platform must be coordinated with the floor of the vehicles it serves to minimize the vertical and horizontal gaps, in accordance with the ADA Accessibility...
-
10.3.1(9)
(9) In stations covered by this section, rail-to-platform height in new stations shall be coordinated with the floor height of new vehicles so that the vertical difference, measured when...
-
Edge Protection [4.8.7]
Horizontal rails are another alternative although mounting heights are not specified (the 27 inch height in ADAAG Figure 17 pertains to the return of extensions as protruding objects)....
-
Gurney Accessible Bathroom
wall for shower gurney access Vanity remodeled to clear the space for wheelchair users Hand-held shower 6’ hose on shower Shower heads at four different heights...
-
§ 38.175(a)
design of cars shall be coordinated with the boarding platform design such that the horizontal gap between a car door at rest and the platform shall be no greater than 3 inches and the height...
-
Comments on specific provisions of proposed ADAAG (Preamble, Section-by-Section Analysis)
Strenuous objections were raised by some business commenters to the proposed provisions of the guidelines concerning check-out aisles, counters, and scoping for hotels and nursing facilities...
-
M307.2 Tactilely Discernible (Section-by-Section Analysis)
The most common method to ensure that buttons and similar controls are tactilely discernible is to raise part or all of the control surface above the surrounding surface and at a distance...
-
M101.5 Dimensions (Section-by-Section Analysis)
One commenter and the MDE Advisory Committee raised concerns about providing standards for obese patients and pediatric patients....
-
(a) Single-story dwelling units
Sunken or raised functional areas, such as a sunken living room, are also exempt from access specifications, provided that such areas do not interrupt the accessible route through the remainder...
-
Employee for ADA Compliance
The designated employee(s) or consultant shall be knowledgeable about or receive training on the ADA, shall serve as the primary contact(s) on disability-related issues and concerns raised...
-
Employee for ADA Compliance
The designated employee(s) or consultant shall be knowledgeable about or receive training on the ADA, shall serve as the primary contact(s) on disability-related issues and concerns raised...
-
4.10.14* EMERGENCY COMMUNICATIONS
It shall be identified by a raised or recessed symbol and lettering complying with 4.30 and located adjacent to the device....
-
§ 37.47(e)
., installations of elevators, raising the entire passenger platform, or alterations of similar magnitude and cost)....
-
Jean Tessmer
I have used this tool for concrete, asphalt, and raised board walk construction work on federal and private commercial projects....
-
1134A.6, Item 4
The grab bar reinforcement shall be a minimum of 6 inches (152.4 mm) nominal in height. ...
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm). Thresholds shall comply with the following:...
-
1134A.6, Item 4
The grab bar reinforcement shall be a minimum of 6 inches (152.4 mm) nominal in height....
-
§ 38.153(c)(1)
(1) Doors shall have a minimum clear width when open of 30 inches (760 mm), measured from the lowest step to a height of at least 48 inches (1220 mm), from which point they may taper to...
-
11B-809.10.6.4 Reinforcement for grab bars
The grab bar reinforcement shall be 8 inches (203 mm) minimum in height....
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
11B-207.1 General
The directional signs must comply with the requirements of Section 11B-703.5 for visual characters. ◼...
-
Pilot Rock WXT and WXTH Picnic Table Using Lumber
Nominal seat height is 18”. The WXTH Series offers clearances under the table top of 30” wide, 31” high and 24” total knee and toe clearance (19” knee and 5” toe). ...
-
Pilot Rock WUT and WUTH Picnic Table Using Recycled Plastic
Nominal seat height is 18”. The WUTH Series offers clearances under the table top of 30” wide, 31” high and 24” total knee and toe clearance (19” knee and 5” toe). ...
