information dissemination, and other programs with respect to blinding eye diseases, visual disorders, mechanisms of visual function, preservation of sight, and the special health problems and requirements...
Search Results "Technical Requirement"
Commonly Searched Documents
- Low Vision Part 3: How Can People With Low Vision Maintain Their Independence?
- Yale 4700LN Series Grade 1 Cylindrical Locks
- Takeform Fusion Signage Interior Stairwell Type N
- ASTM International
-
§1607.6 Use of selection procedures which have not been validated.
When a formal and scored selection procedure is used which has an adverse impact, the validation techniques contemplated by these guidelines usually should be followed if technically feasible...
-
A. Accessibility of Web Information
The Department will continue to assess whether specific technical standards are necessary and appropriate to assist covered entities with complying with the ADA....
-
R218 Doors, Doorways, and Gates
The SNPRM would not apply the technical provisions for doors, doorways, and gates referenced in R218 to shared use paths to avoid conflicts with the AASHTO Guide....
-
References
References Axelson PW, Chesney D (April 1999): “Accessible Exterior Surfaces Technical Report,” USATBCB, Washington, DC....
- Trimco LDH100 Series Lockdown Hardware
- Department of Homeland Security
-
Changes in Level within a Dwelling Unit
In House Report No. 711, the Congress repeatedly emphasized that the accessibility requirements of the Fair Housing Act were minimal basic requirements of accessibility....
-
16. If, as a reasonable accommodation, an employer restructures an employee's job to eliminate some marginal functions, may the employer require the employee to take on other marginal functions that s/he can perform?
Yes. An employer may switch the marginal functions of two (or more) employees in order to restructure a job as a reasonable accommodation. Example: A cleaning crew works in an...
-
G.3.ii. - Are some types of secure electronic equipment, such as secure telecommunications devices that are specifically designed to prevent eavesdropping and other forms electronic attack, subject to Section 508 requirements?
Unless an exception applies, these technologies are considered EIT and must meet the Access Board standards. If "Tempest-tested" telecommunications systems are being used in an...
-
Appendix E—Guidance to Revisions to ADA Title II and Title III Regulations Revising the Meaning and Interpretation of the Definition of “disability” and Other Provisions in Order To Incorporate the Requirements of the ADA Amendments Act
For guidance providing a section-by-section analysis of the revisions to 28 CFR parts 35 and 36 published on August 11, 2016, see appendix C of 28 CFR part 35. [AG Order...
- How to File a Complaint with the Federal Communications Commission (FCC)
-
1. Standing Supports
The proposed rule included a provision requiring standing supports on each side of the standing surface and compliance with the technical requirements for standing supports in proposed M305.3...
-
General: ADA Standard Section 229.1
Section 229.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for windows.
- California Foundation for Independent Living Centers - Sacramento, CA
- Pennsylvania Office of Vocational Rehabilitation (OVR)
-
c. Transfer Surface Size for Diagnostic Equipment Used by Patients in the Supine, Prone, or Side-lying Position
The MDE Advisory Committee also recommended the addition of an exception for imaging equipment transfer surface size; to allow a decrease in depth to no less than 21 inches where it is technically...
- Yale 4600LN Series Grade 2 Cylindrical Locks
-
T215 Communication Features
In the 2010 NPRM, the scoping requirements for communication features were scattered throughout Chapter 2....
- Institute for Human Centered Design (IHCD)
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
Multiple commenters expressed concerns that transfer cannot always occur at the end of the diagnostic equipment as contemplated by the requirements in the proposed rule....