These devices consist of a single-wheel "half bike" in a child's size that can be attached to the back of a standard adult bicycle (or a tandem). These devices are relatively rare....
Search Results "Qualification Standard"
Filters
Commonly Searched Documents
-
Trailer Bicycles
-
Is there a limit on the total length (number of runs) a ramp may have?
No, the Standards limit the rise of each run (30” max.), but not the overall length of ramps comprised of multiple runs....
-
How are parking spaces and access aisles to be marked?
The ADA Standards do not specify the method or color of parking space and access aisle markings. State or local codes and regulations may specify such markings....
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
-
Existing play areas. (Section-by-Section Analysis)
These guidelines filled a void left by the 1991 Standards....
-
11B-206.2.8 Employee work areas
[2010 ADA Standards] 1....
-
11B-221.1 General
[2010 ADA Standards] 221.1 General. Assembly areas shall provide wheelchair spaces, companion seats, and designated aisle seats complying with 221 and 802....
-
C. First Advance Notice of Proposed Rulemaking (2010)
General Based on the TEITAC Report, the Board developed an Advance Notice of Proposed Rulemaking in 2010 (2010 ANPRM) to update the 508 Standards as well as the 255 Guidelines....
-
4.2 Stretchers
The MDE Advisory Committee therefore included stretchers among MDE requiring consideration in setting accessibility standards....
-
John Brabyn, Ph.D., Director of Rehabilitation Engineering Research, Center on Low Vision and Blindness (NIDRR), Smith-Kettlewell Eye Research Institute
Introduction Some Vision Research Relevant to Built Environment Codes & Standards (slide 1) Research is being funded by NIH/NEI. No standardized tests for glare....
-
Organization of This Rule
Throughout this rule, the original ADA Standards, which are republished as Appendix D to 28 CFR part 36, will be referred to as the ‘‘1991 Standards.’’...
-
Table 3
Proposed Guidelines Contain Requirements Not in DOJ 2010 Standards Table 3 analyzes requirements in the proposed guidelines for which there are no corresponding requirements in the DOJ...
-
68.74. Continuing Education
topics: (A) Texas Government Code, Chapter 469, Elimination of Architectural Barriers (B) 16 Texas Administrative Code, Chapter 68 – Administrative Rules; (C) Texas Accessibility Standards...
-
Plan 3B: 12-Foot Wide Accessible Guest Room
Plan 3B: 12-Foot Wide Accessible Guest Room This drawing shows an accessible 12-foot wide guest room with features that comply with the 2010 Standards....
-
Plan 2A: 13-Foot Wide Accessible Guest Room
Plan 2A: 13-Foot Wide Accessible Guest Room This drawing shows an accessible 13-foot wide guest room with features that comply with the 2010 Standards....
-
Alterations to Residential Facilities
The 2010 Standards, at sections 202.3 Exception 3, 202.4, and 233.3, contain specific scoping requirements for alterations to dwelling units....
-
M101.2 Application (Section-by-Section Analysis)
In the NPRM the Access Board proposed that the MDE Standards would be applied to diagnostic equipment based on the patient position the equipment is designed to support....
-
BACKGROUND
The proposed technical criteria originated from provisions for grab bars in the 2010 Standards....
-
Regulatory Process Matters
The Department's initial regulatory impact analysis measures the incremental benefits and costs of the proposed standards relative to the benefits and costs of the 1991 Standards. ...
-
Maintenance of Accessible Features
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Regulatory Process Matters
The Department's initial regulatory impact analysis measures the incremental benefits and costs of the proposed standards relative to the benefits and costs of the 1991 Standards. ...
-
216.4.3 Directional Signs
by section 1003.2.13.6 of the International Building Code (2000 edition) or section 1007.7 of the International Building Code (2003 edition) (incorporated by reference, see "Referenced Standards...
-
503 Passenger Loading Zones
For consistency with the ANSI A117.1 standard, the Board has clarified in the final rule that access aisles required at passenger loading zones are not permitted to overlap vehicular ways...
-
12114(c)(5)(A)
(A) employees comply with the standards established in such regulations of the Department of Defense, if the employees of the covered entity are employed in an industry subject to such regulations...