The proposed standards apply to fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site....
Search Results "Fixed Assembly Seating"
Filters
Commonly Searched Documents
-
§ 35.151(d) Scope of coverage
-
12143(c)(2) Service area
under this section shall require the provision of paratransit and special transportation services required under this section in the service area of each public entity which operates a fixed...
-
Adjustable height protocol
Adjustable height protocol: From initial setup, only the height of the platform was adjusted incrementally: higher (Figure 3) and lower than the subject’s seat. ...
-
11B-1009.2 Pool lifts
There are a variety of seats available on pool lift. Pool lift seats with backs enable a larger population of persons with disabilities to use the lift....
-
Benches
In saunas and steam rooms, this floor space may be obstructed by readily removable seats....
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
Homemods.org
In some cases, modifying the home may also require repairs such as improved wiring to eliminate the need for dangerous extension cords or fixing loose stair treads....
-
§382.41(a)
(a) The specific location of seats, if any, with movable armrests (i.e., by row and seat number);...
-
4.4.1 General
Section 4.3.1 does not apply to built-in benches provided in assembly areas such as amphitheaters. These benches are covered by sections F221.2.1.1, F221.2.2, and 903 of the ABAAS....
-
Places of Public Accommodation and Commercial Facilities
categories listed in the statute, including stores and shops, restaurants and bars, sales or rental establishments, service establishments, theaters, places of lodging, recreation facilities, assembly...
-
§382.61(a)
(a) As a carrier, you must ensure that aircraft with 30 or more passenger seats on which passenger aisle seats have armrests are equipped with movable aisle armrests on at least one-half...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
1015.3 Height
The guard height in assembly seating areas shall comply with Section 1029.17 as applicable....
-
11B-224.8.2 More than 50-bed facilities
Facilities with more than 50 beds that provide common use bathing facilities, shall provide at least one roll-in shower with a seat that complies with Section 11B-608....
-
Drinking Fountains and Water Coolers
Comments advised that the guidelines should not address "water coolers," a term which is often used to refer to bottled units that are not plumbed or permanently fixed. Response....
-
218 Transportation Facilities
Section 218 provides requirements for rail stations, fixed guideway systems, bus shelters, and other transit facilities, such as airports....
-
Technical Memorandum TM 2013-15 Baby Changing Tables
TM 2013-15 Baby Changing Tables Effective Date: June 1, 2013 2012 TAS Reference: 902 Baby changing tables are work surfaces based on Advisory 902.1; therefore, if fixed...
-
§ 36.406(b) Scope of coverage.
The 1991 Standards and the 2010 Standards apply to fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site....
-
Question 17
Should the standards be different for adjustable beds, such as hospital beds, and for fixed height beds?...
-
A4.34.6.7 OVENS
The pullout board or fixed shelf under side-opening oven doors provides a resting place for heavy items being moved from the oven to a counter....
-
7. Medicine
A passenger's request to take medication while aboard a fixed route or paratransit vehicle or in a transit facility should be granted....
-
§ 37.23(b)
(b) A private entity which purchases or leases new, used, or remanufactured vehicles, or remanufactures vehicles, for use, or in contemplation of use, in fixed route or demand responsive...
-
§ 35.151(d) Scope of coverage.
The 1991 Standards and the 2010 Standards apply to fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site....