The structural strength of grab bars, tub and shower seats, fasteners, and mounting devices shall meet the following specification:...
Search Results "Boarding Device"
-
4.26.3 Structural Strength
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309 _|Operable Parts|_....
-
If the lift manufacturer specifies that wheelchairs must face away from the vehicle when using the lift, are transportation operators required to permit passengers to board facing the vehicle?
Yes. 49 CFR Part 38 specifies that a lift must permit both inboard and outboard facing of wheelchair users. A lift that requires passengers to face a specific direction does not...
-
L. Availability of Electrical Power
The back-up power is needed to provide refrigeration of medicines, operation of supplemental oxygen and breathing devices, and for charging the batteries of power wheelchairs and scooters...
-
Clear Floor Space: Minimum Clear Floor Space Required - Manual, Power & Scooter
This data provides the minimum dimensions for the rectangular floor area required by occupied wheeled mobility devices (i.e., with the occupant seated in their own wheeled mobility device...
-
11B-604.5.2 Rear wall
Patient toilet rooms with bedpan flushing devices are an allowance, not a requirement....
-
11B-604.5.2 Rear wall
Patient toilet rooms with bedpan flushing devices are an allowance, not a requirement....
-
707 Automatic Teller Machines and Fare Machines
Federal procurement law requires that ITMs purchased by the Federal government comply with standards issued by the Access Board under Section 508 of the Rehabilitation Act of 1973, as amended...
-
811 Storage
These provisions have been moved to Chapter 8, which the Board considers a more appropriate location because it covers accessible spaces and elements....
-
Resting Intervals [1018.8]
When the surface of the resting interval is constructed of asphalt, concrete, or boards, the slope of the resting interval must be no steeper than 1:48 (2 percent) in any direction....
-
Delimitations
Access Board in the Notice of Proposed Rulemaking for Outdoor Developed Areas (U.S. Access Board, 2007)....
-
707 Automatic Teller Machines and Fare Machines
Federal procurement law requires that ITMs purchased by the Federal government comply with standards issued by the Access Board under Section 508 of the Rehabilitation Act of 1973, as amended...
-
Figure 1005.3.2 Extended Ground or Deck Surface at Fishing Piers and Platforms – Drawing from the U.S. Access Board
-
Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance – Drawing from the U.S. Access Board
-
Figure 703.4.1 Height of Tactile Character Above Finish Floor or Ground – Drawing from the U.S. Access Board
-
Figure 608.2.2 Standard Roll-In Type Shower Compartment Size and Clearance – Drawing from the U.S. Access Board
-
Figure 608.5.3 Alternate Roll-In Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
Figure 608.5.2 Standard Roll-In Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
4.1 Introduction
This reach limit should be used to identify the low range of safe reach but not to specify the location of all outlets or other devices....
-
F206.8 Security Barriers
[ECTCR UFAS 7.4] EXCEPTION: Where security barriers incorporate elements that cannot comply with these requirements such as certain metal detectors, fluoroscopes, or other similar devices...
-
225(a)(3) Telecommunications relay services
Such term includes services that enable two-way communication between an individual who uses a TDD or other nonvoice terminal device and an individual who does not use such a device....
-
Measuring Opening Force
It does not apply to the force required to retract bolts or to disengage other devices used to keep the door in a closed position....
-
4.4.3 Backrest and Armrest
The structural strength of backs, armrests, and mounting devices shall comply with section 903.6 of the ABAAS, which states: “Allowable stresses shall not be exceeded for materials used...
-
1010.1.9.1 Hardware
Door handles, pulls, latches, locks and other operating devices on doors required to be accessible by Chapter 11A or 11B shall not require tight grasping, tight pinching or twisting of the...
