Accessibility Measures All surfaces were measured with the rotational penetrometer periodically over the first 6 months of exposure (Fig. 9)....
Search Results "Unit of Measurement"
-
Test Procedures
-
B. Technical standards for criterion-related validity studies
The possibility of bias should be considered both in selection of the criterion measures and their application....
-
4.1.2(5)(d)(ii)
(ii) Units and facilities that specialize in treatment or services for persons with mobility impairments: 20 percent of the total number of parking spaces provided serving each such unit...
-
Inclusion Solutions ADA Parking Mat
Mat measures 36"h x 30"w and is polyester with a protective coating to improve durability with a self-adhesive backing....
-
607 Bathtubs
Specifications for bathtubs in section 607 address clear floor space, seats, grab bars, operable parts, shower spray units, and enclosures....
-
SCOTT JOHNSON v. STARBUCKS CORPORATION - AMICUS BRIEF
ANDERSON (CABN 149604) United States Attorney SARA WINSLOW (DCBN 457643) Chief, Civil Division ELLEN LONDON (NYRN 4605671) Assistant United States Attorney 450 Golden Gate Avenue...
-
TEST NO. 2 – SITE ANALYSIS TEST
In no case shall less than 20 percent of the ground floor dwelling units be on an accessible route and comply with the provisions of Division IV. 3....
-
TEST NO. 2 – SITE ANALYSIS TEST
In no case shall less than 20 percent of the ground floor dwelling units be on an accessible route and comply with the provisions of Division IV....
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
T304.3 Location
Operable parts provided at a wheelchair space shall be located adjacent to the wheelchair space 24 inches (610 mm) minimum and 36 inches (915 mm) maximum from the rear of the wheelchair space measured...
-
T702.6 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
T502.2 Doorways with Lifts, Ramps or Bridgeplates
Vertical clearance shall be measured from the inside finished edge of the door opening to the highest point of the deployed lift, ramp or bridgeplate below....
-
Knee and Toe Space
The knee and toe space must be at least as deep as the reach depth measured from the leading edge of the obstruction....
-
Carpenter's levels
To determine angles the level must be used with a measuring tape to determine slope....
-
11B-604.9.3 Height
The height of water closets shall be 11 inches (279 mm) minimum and 17 inches (432 mm) maximum measured to the top of the seat....
-
11B-703.5.8 Character spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
Indefinite Leave to Remain UK: What Applicants Should Know Before Applying
Securing Indefinite Leave to Remain UK is an important step for individuals aiming to settle permanently in the United Kingdom....
-
Monetary Relief for Complainant
Blockbuster will deliver the check to counsel for the United States by common carrier United Parcel Service, delivery prepaid, to the following address: William Lynch, Trial Attorney, Disability...
-
MONETARY RELIEF FOR THE COMPLAINANT
States and will simultaneously send a copy of the check and the accompanying letter to the United States. ...
-
§8.3 Adaptability
Adaptability means the ability of certain elements of a dwelling unit, such as kitchen counters, sinks, and grab bars, to be added to, raised, lowered, or otherwise altered, to accommodate...
