When a new viewing area is constructed, or an existing viewing area is altered or reconstructed, if a condition for exception in section 1.1 prohibits full compliance with a specific requirement...
Search Results "Existing Site Constraints"
-
3.4.1 General
-
2.3.1
If industry standards exist for measurement protocols, these should be referenced....
-
11B-213.3 Plumbing fixtures and accessories
The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
Subpart B -- General Requirements (Section-By-Section Analysis and Response to Comments)
These general prohibitions are patterned after the basic, general prohibitions that exist in other civil rights laws that prohibit discrimination on the basis of race, sex, color, religion...
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
2. Priority Guidelines for Removal of Access Barriers
Priority Guidelines for Removal of Access Barriers In selecting, removing, and remediating existing access barriers, the City will exercise its discretion and give priority to Pedestrian...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor when a parallel approach is provided...
-
11B-213.3 Plumbing fixtures and accessories
The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
11B-608.7 Thresholds
Exception: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a ½ inch (12.7 mm) high threshold would...
-
Community Resources for Independence (CRI) - Allentown, Indiana, Erie, Altoona, Bradford, Clearfield, Hermitage, Lewisburg, Lewiston, McConnellsburg, Seneca, Warren, Wellsboro, and Somerset, PA
CRI's professionally trained staff, many of whom have disabilities themselves, provide services, peer support, and referrals to existing community resources. ...
-
Number Limits
view of the matter has been strengthened by the fact that, during the 17 years since the original rule was issued, we are not aware of any instances of safety problems resulting from the existing...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
404.2.10 Door and Gate Surfaces
ETA Editor’s Note: An existing door with a noncompliant kick plate is a safe harbored element for path of travel and barrier removal purposes but will have to comply when the door is...
-
206.2.5 Restaurants and Cafeterias
In alterations, an accessible route shall not be required to existing raised or sunken dining areas, or to all parts of existing outdoor dining areas where the same services and decor are...
-
405.1 General (Section-by-Section Analysis)
This proposed section closely corresponds to existing 508 Standards §§ 1194.21(k), 1194.22(j), and 1194.25(i), and is similar to § 1193.43(f) of the existing 255 Guidelines....
-
4.34.4 CONSUMER INFORMATION
To ensure that the existence of adaptable features will be known to the owner or occupant of a dwelling, the following consumer information shall be provided in each adaptable dwelling unit...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
Costs to Provide Accessible Pedestrian Signals and Pedestrian Pushbuttons (Section-by-Section Analysis)
estimated that pedestrian signals are newly installed or replaced at 13,095 signalized intersections on an annual basis based on the following assumptions: There are over 300,000 existing...
-
49 CFR Parts 37 and 38 -- Transportation for Individuals With Disabilities at Intercity, Commuter, and High Speed Passenger Railroad Station Platforms; Miscellaneous Amendments, Preamble
Passenger railroads must provide level-entry boarding at new or altered stations in which no track passing through the station and adjacent to platforms is shared with existing freight rail...
-
VII. Effective Date
to the FAR Council for establishment of the date on which the revised 508 Standards apply to new ICT-related contracts awarded after publication of the Council’s final rule, as well as existing...
-
11B-206.4.10 Medical care and long-term care facilities
For existing buildings that do not have a protected accessible entrance, projects subject to Section 11B-202 are not required to provide one. ...
-
B. Proposed 255 Guidelines
The existing guidelines include detailed requirements for the accessibility, usability, and compatibility of telecommunications equipment and customer premises equipment....
-
2. Accessible lavatories
As under the existing rule, this requirement would apply to new aircraft (i.e., aircraft ordered/delivered after the effective date of the rule)....
