For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
Search Results "Companion Seat"
Commonly Searched Documents
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
- Adaptive Access
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
-
11B-209.4 Valet parking
Some vehicles may be adapted with hand controls or lack a driver’s seat, and may not be operable by a valet parking attendant....
-
Technical Memorandum TM 2013-11 Benches
Steam Rooms TAS 612.2 Dressing, Fitting, and Locker Rooms TAS 803.4 Holding Cells and Housing Cells TAS 807.2.2 Fixed or built-in benches and other types of fixed seating...
-
H29
Accessible Shower Stall Minimum Size and Clearances Accessible Shower Stall Grab Bars and Seat, Shower, and Control Area...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
Printable Room Layouts
If your meeting will have more than 10% of attendees using mobility devices or service animals, increase the number of accessible seating locations and aisle widths proportionally....
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Users may slide off the seat and fall onto the floor of the shower while reaching for the shower controls and hand-held showerhead. Requirement: 4.21.2 Size and Clearances....
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
- Landscape Forms Inc. Olithas Outdoor Table
- Hoyer Manual Hydraulic Lift
- Living Earth Crafts Essex™ Pedicure Chair
- Listen Technologies ADA Assistive Listening Device Calculator
-
11B-233.3.6 Graduate student and faculty housing at a place of education
806.2.3 of the 2010 Standards. 2) Facilities with more than 50 beds covered by this part that provide common use bathing facilities shall provide at least one roll-in shower with a seat...
-
ASME
This document does not permit the use of inclined stairway chairlifts which do not provide platforms because such lifts require the user to transfer to a seat....
-
11B-216.1 General
Building directories, menus, seat and row designations in assembly areas, occupant names, building addresses, and company names and logos shall not be required to comply with Section 11B...
-
2.3.2 IR Receivers
Some receivers include an environmental microphone to permit the direct audio reception of one's companions while using the IR receiver....
-
2.3.3 Issues
There are no standards which specify the radiated level of light required at seat locations. At least one manufacturer (Audex) makes a light meter available for installers....
-
201.1.1 Vertical accessibility
(4) Theaters, concert halls, and stadiums, or other large assembly areas that have stadium-style seating or tiered seating if sections 221 and 802 are met....
-
B. Carrier-Supplied Oxygen
The Oxygen NPRM proposed to require certificated U.S. carriers operating aircraft that conduct passenger-carrying service with at least one aircraft having a designed seating capacity of...