The Pathway Measuring Tool (PathMeT) we have developed is capable of measuring the profile of the surface to a resolution of smaller than 1 mm....
Search Results "AHJ: Authority Having Jurisdiction"
Filters
Commonly Searched Documents
-
Future Work
-
4. Benefits—Qualitative Discussion of Benefits
attended movies anyway but under the rule will have a fuller and more pleasant experience will likely also change....
-
Speech Output
In the past year, the Board has become aware of various banks in different areas of the country that have provided new talking ATMs that take advantage of improved speech output technologies...
-
11B-804.6.5.2 Bottom-hinged door ovens
Bottom-hinged door ovens shall have the work surface required by Section 11B-804.3 positioned adjacent to one side of the door....
-
1630.2(l)(3)
(3) Has none of the impairments defined in paragraphs (h)(1) or (2) of this section but is treated by a covered entity as having a substantially limiting impairment....
-
M102.3 Interchangeability (Section-by-Section Analysis)
There were no comments on this requirement and no changes have been made...
-
703.6.3 Text Descriptors
Pictograms shall have text descriptors located directly below the pictogram field. Text descriptors shall comply with 703.2, 703.3 and 703.4...
-
§ 1194.25(j)
(j) Products which are freestanding, non-portable, and intended to be used in one location and which have operable controls shall comply with the following:...
-
703.6.3 Text Descriptors
Pictograms shall have text descriptors located directly below the pictogram field. Text descriptors shall comply with 703.2, 703.3 and 703.4....
-
§8.3 Historic preservation programs or activities
Historic preservation programs or activities means programs or activities receiving Federal financial assistance that have preservation of historic properties as a primary purpose....
-
704.2.2 Operable Parts
Telephones shall have push-button controls where such service is available....
-
11B-703.7.2.6.4 Edges and corners
Corners of signs shall have a minimum radius of 1/8 inch (3.2 mm)....
-
E207.1 General
Where components of ICT are software and transmit information or have a user interface, such components shall conform to E207 and applicable requirements in Chapter 5....
-
703.6.3 Text Descriptors
Pictograms shall have text descriptors located directly below the pictogram field. Text descriptors shall comply with 703.2, 703.3 and 703.4....
-
4.1.2(7)(c)
(c) Accessible entrances when not all are accessible (inaccessible entrances shall have directional signage to indicate the route to the nearest accessible entrance);...
-
A4.9.1 Minimum Number
Only interior and exterior stairs connecting levels that are not connected by an elevator, ramp, or other accessible means of vertical access have to comply with 4.9....
-
4.7.7 Detectable Warnings
A curb ramp shall have a detectable warning complying with 4.29.2. The detectable warning shall extend the full width and depth of the curb ramp....
-
AGREED RESOLUTION
The parties have therefore agreed as follows:...
-
4.1.5(1) ENTRANCES
If a new addition to a building or facility does not have an entrance, then at least one entrance in the existing building or facility shall comply with 4.1.4, Entrances....
-
§100.201 Ground floor
A building may have more than one ground floor....
-
Can curb ramps overlap access aisles?
No, access aisles, as well as vehicle pull-up spaces, cannot have changes in level other than slopes not exceeding 1:48....
-
11B-804.6.5.2 Bottom-hinged door ovens
Bottom-hinged door ovens shall have the work surface required by Section 11B-804.3 positioned adjacent to one side of the door....
-
§ 37.155(a)(9)
(9) Evidence of increased efficiencies, that have been or could be effectuated, that would benefit the level and quality of available resources for complementary paratransit service; and...
-
§ 38.39(a)
(a) Where destination or route information is displayed on the exterior of a vehicle, each vehicle shall have illuminated signs on the front and boarding side of the vehicle....