While the Access Board did not establish specific design requirements for dispersion in the 2004 ADAAG, in response to extensive comments in support of dispersion it added an advisory note...
Search Results "Vertical Dispersion"
-
Section 35.151(h) Medical care facilities
-
Section 36.406(g) Medical Care Facilities
While the Access Board did not establish specific design requirements for dispersion in the 2004 ADAAG, in response to extensive comments in support of dispersion it added an advisory note...
-
General: ADA Standard Section 208.3.1
Section 208.3.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for parking space locations.
-
11B-208.3.2 Residential facilities
Spaces provided in accordance with Section 11B-208.2.3.2 shall be dispersed throughout all types of parking provided for the residential dwelling units....
-
11B-208.3.2 Residential facilities
Spaces provided in accordance with Section 11B-208.2.3.2 shall be dispersed throughout all types of parking provided for the residential dwelling units....
- Garaventa Elvoron CPL Vertical Platform Lift
-
9.1.4(1)
persons with disabilities a range of options equivalent to those available to other persons served by the facility, sleeping rooms and suites required to be accessible by 9.1.2 shall be dispersed...
-
M305.3.2.2 Vertical Position
The height of the lowest end of the gripping surface on vertical standing supports shall be 34 inches (865 mm) minimum and 37 inches (940 mm) maximum above the standing surface....
-
Dispersion of Wheelchair Seating Areas (Section-By-Section Analysis and Response to Comments)
- Dispersal of wheelchair seating areas in theaters will be required only where there are more than 300 seats, rather than in all cases....
- Figure 307.4 Vertical Clearance – Drawing from the U.S. Access Board
-
M305.3.2 Vertical Position
Where the support is vertical, it shall be 18 inches (455 mm) minimum in length and the bottom end of the support shall be 34 inches (865 mm) high minimum and 37 inches (940 mm) high maximum...
-
503.5 Vertical Clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone, and from the passenger loading zone to a vehicular exit shall provide a vertical...
- Garaventa Genesis Shaftway - Vertical Platform Lift
-
5.4 Dining Areas
In non-elevator buildings, an accessible means of vertical access to the mezzanine is not required under the following conditions: 1) the area of mezzanine seating measures no more than...
-
503.5 Vertical Clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone, and from the passenger loading zone to a vehicular exit shall provide a vertical...
-
11B-233.3.5 Dispersion
809.4 and residential dwelling units required to provide communication features complying with Section 11B-809.5, and adaptable features complying with Chapter 11A, Division IV shall be dispersed...
-
11B-233.3.5 Dispersion
809.4 and residential dwelling units required to provide communication features complying with Section 11B-809.5, and adaptable features complying with Chapter 11A, Division IV shall be dispersed...
-
11B-503.5 Vertical clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone and from the passenger loading zone to a vehicular exit shall provide a vertical...
- Harmar RPL Residential Vertical Platform Lift
- Harmar EPL Enclosed Vertical Platform Lift
-
Wheelchair Seating Locations
Where the seating capacity exceeds 300, wheelchair locations are required to be dispersed in most cases....
-
Is vertical access required to all levels of a parking garage?
Vertical access must be provided as necessary to address any changes in level along these required accessible routes....
-
Van Spaces
Recommendation: Where accessible spaces are dispersed within a lot, consider providing van access at each location....
-
407.8.2 Side Reach
The vertical reference plane shall be centered on the operable part and placed at the leading edge of the maximum protrusion of the ICT within the length of the vertical reference plane....