Trails shall comply with 1017. EXCEPTIONS: 1. ...
Search Results "Trail"
Commonly Searched Documents
-
1017.1 General
-
1017.1 General
Trails shall comply with 1017. EXCEPTIONS: 1....
- Stabilizer Solutions Natural Decomposed Granite Pathway Stabilizer
-
Surface
Surface—The top layer of ground on a recreation site, outdoor recreation access route, trail, or beach access route Firm. A surface that resists deformation by indentations....
-
7.4.5 Passing Spaces
Trails with a clear tread width less than 60 inches (1525 mm) shall provide passing spaces complying with 7.4.5 at intervals of 1000 feet (300 m) maximum. ...
-
1017.8.3 Slope
Resting intervals shall have slopes not steeper than 1:48 in any direction. EXCEPTION: Where the surface is other than concrete, asphalt, or boards, cross slopes not steeper than...
-
Outdoor Constructed Features
[See subsections ...]
-
7.4.12.2 Gate Hardware
Gate hardware shall comply with operable controls requirements in ABAAS section 309.4 and 404.2.7.
-
1017.8.3 Slope
This section requires the slope of resting intervals to not be steeper than 1:48 in any direction. Where the surface is other than asphalt, concrete, or boards, slopes not steeper...
-
1017.8.3 Slope
Resting intervals shall have slopes not steeper than 1:48 in any direction. EXCEPTION: Where the surface is other than concrete, asphalt, or boards, cross slopes not steeper than...
-
7.3 Definitions
All trail-related definitions used in the FSTAG are from the Forest Service Manual or Handbook, the Forest Service Infra Trails Module, Trail Assessment and Condition Survey (TRACS) reference...
-
Conditions for an Exception in FSTAG
If a condition for an exception occurs only on part of the trail or trail component, the technical requirement applies everywhere else....
-
Exemptions for Entire Trail or Beach Access Route
percent for over 20 feet; A trail obstacle 30 inches high or more runs across the full tread width of the trail; The trail surface is neither firm nor stable for a distance...
-
1017.5 Tread Obstacles
Tread obstacles on trails, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
1017.5 Tread Obstacles
Tread obstacles on trails, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
F247.4.4 Routes
Routes that connect trails complying with 1017 to camping facilities, picnic facilities, viewing areas, pit toilets, and accessible elements provided within the facilities shall comply with...
-
Firm
Firm. A firm surface resists deformation by indentations. During the planning process, firmness must be evaluated for noticeable distortion or compression during the seasons...
-
Stable
Stable. A surface is not permanently affected by expected weather conditions and can sustain normal wear and tear from the expected use(s) of the area, between planned...
-
7.4.12.1 Clear Width
Gate openings and openings in barriers for hiker passage shall provide a clear width of 36 inches (915 mm), complying with ODAAG, section 1017.3 Clear Tread Width.
-
Trailheads
hiking, at least one outdoor recreation access route must connect the following places at trailheads: Accessible parking spaces or other arrival point Starting point of the trail...
-
Notification Forms
an exemption for the entire trail or beach access route (see 1017.1, exception 2 and 1018.1, exception 2)....
-
Accessing Arizona
Accessing Arizona is an eMagazine. Its designed to give people with disabilities a resource for finding out whats going on in Arizona. For people vacationing in Arizona, or traveling...
-
7.2.2.1 Determining Impracticability
The combination of trail running slope (grade) and cross slope exceeds 1:2.5 (40 percent) for over a distance of 20 feet (6m). Limiting Factor 2. ...
-
5.1.2 Level or Sloped Entry
If the camp shelter is located off a trail, the sloped entry is to comply with the FSTAG Trail provisions....