b) What would be the incremental costs for the design or redesign and manufacture of the equipment to provide handrails on diagnostic equipment ramps that conform to these technical criteria...
Search Results "Incremental Cost"
Commonly Searched Documents
-
Additional Technical Criteria Considered for Handrails on Ramps
-
V. Background on This Rulemaking and Public Comments Received
These commenters asserted that the Department’s discussion of the potential costs for testing entities or educational entities of complying with the ADA Amendments Act and this rule could...
-
11B-704.3 Volume control telephones
For incremental volume control, provide at least one intermediate step of 12 dB of gain minimum. An automatic reset shall be provided....
-
5.1.1 Transfer Surface Height Adjustability
The transfer surface should have an adjustable height in small virtually continuous increments....
-
1.1.5 Flatness of walk running slope
For pedestrian paths up to and including 6 ft (1.8 m) wide, measure for flatness of the running slope at 10 ft (3 m) increments along the midpoint of the width of the walk by using a 10...
-
B. Regulatory Flexibility Act
These costs, which should be considered an upper-bound estimate, are reflected below: Table 8-Estimated Incremental Costs for Small Manufacturing Firms Subject to the Proposed 255 Guidelines...
-
Additional Information
Final Regulatory Impact Analysis The Final RIA embodies a comprehensive benefit-cost analysis of the final rules for both title II and title III and assesses the incremental benefits and...
-
Transfer Supports (M301.3.1, M302.3.1, and M305.2)
If the transfer supports are not currently capable of resisting these forces, what would be the incremental costs for the design or redesign and manufacture of the equipment to provide transfer...
-
Side guard protocol
Then the height of the platform was adjusted incrementally in height: higher and lower than the subject’s seat and the maximum transfer heights high/low that were attainable were recorded...
-
e. Projected Reporting, Record-Keeping Requirements and Other Compliance Requirements of the Rule
and incremental increase to staff time; costs of adding information that captioning or audio description is available when preparing communications regarding movie offerings, and other...
-
§ 1194.23(f)
For incremental volume control, at least one intermediate step of 12 dB of gain shall be provided....
-
1. Purpose and Need for Rule and Scope of Regulatory Assessment
The purpose of the Final RA is to capture the incremental costs of the rulemaking....
-
402.3.2 Non-private Listening
Where ICT provides non-private listening, incremental volume control shall be provided with output amplification up to a level of at least 65 dB....
-
M306 Communication
b) What would be the incremental costs for the design or redesign and manufacture of the equipment to provide all three methods of communication (i.e., audible, visible, and tactile)?...
-
§ 36.403(a)(1)
place of public accommodation or commercial facility in accordance with the specifications in the 1991 Standards, the private entity is not required to retrofit such elements to reflect incremental...
-
Adjustable height/gap protocol
height/gap protocol: From the initial setup, a gap separating the device and platform was introduced with the plywood blocks of 3.5” (8.9cm) and then the height of platform was adjusted incrementally...
-
Wheelchair Spaces (M303.2)
dimension (58 inches minimum) that the Access Board is considering requiring in the final standards for wheelchair spaces that can be entered from the front or rear: a) What would be the incremental...
-
Positioning Supports Considered
b) What would be the incremental costs for the design or redesign and manufacture of positioning supports?...
-
General comments regarding safe harbor. (Section-by-Section Analysis)
Some businesses opposed the application of a safe harbor and, instead, encouraged the government to consider other avenues for reducing costs, like providing tax relief for businesses. ...
-
402.3.2 Non-private Listening
Where ICT provides non-private listening, incremental volume control shall be provided with output amplification up to a level of at least 65 dB....
-
Original research for ANSI A117.1 (1957 - 1961)
National Standard Specifications for Making Buildings and Facilities Accessible to, and Usable by, the Physically Handicapped, ramps were assessed for flatness based on measuring 18 - inch increments...
-
§ 1194.25(f)
(f) When products deliver voice output in a public area, incremental volume control shall be provided with output amplification up to a level of at least 65 dB. ...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
in compliance with the accessibility requirements of the immediately preceding edition of the California Building Code, it shall not be required to retrofit such elements to reflect the incremental...
-
Volume Control Telephones: ADA Standard Section 704.3
For incremental volume control, provide at least one intermediate step of 12 dB of gain minimum. An automatic reset shall be provided. Advisory 704.3 Volume Control Telephones....