4.1.2 Surface Design of Examination Tables and Chairs For several reasons including patient comfort and safety, the surfaces of many examination tables and chairs are not flat....
Search Results "Composite Rubber Surface"
Filters
Commonly Searched Documents
-
4.1.2 Surface Design of Examination Tables and Chairs
-
R407.9.1 Extended Ramp Surface
R407.9.1 Extended Ramp Surface. The surface of the ramp run or landing shall extend 305 mm (1.0 ft) minimum beyond the inside face of a handrail complying with R409....
-
504.4 Tread Surface
504.4 Tread Surface. Stair treads shall comply with 302. Changes in level are not permitted. EXCEPTION: Treads shall be permitted to have a slope not steeper than 1:48....
-
General: ADA Standard Section 403.1
Section 403.1 of the ADA Standards covers information in the current ADA Standards for walking surfaces that are part of an accessible route.
-
6.5 Surface
The surface of beach access routes and their related resting intervals shall be firm and stable....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
11B-404.2.4.4 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302. Changes in level are not permitted. Exceptions: 1. ...
-
11B-404.2.4.4 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302. Changes in level are not permitted. Exceptions: 1....
-
Qualitative and Observational Analysis by Surface Type
Qualitative and Observational Analysis by Surface Type The aggregate material listed below contains a size (inch), the label “minus”, and an aggregate type....
-
RESULTS OF OBJECTIVE SURFACE MEASUREMENT
RESULTS OF OBJECTIVE SURFACE MEASUREMENT Wheelchair Work Measurements....
-
Ground Surfaces
Ground Surfaces....
-
Surface [1018.3]
The surface of beach access routes and resting intervals must be firm and stable. Sand is not a firm and stable surface....
-
4.3.2 Transfer Surfaces and Imaging Equipment Functions
4.3.2 Transfer Surfaces and Imaging Equipment Functions The transfer surface (table) of diagnostic imaging equipment serves two purposes: (1) it allows patients to be positioned properly...
-
Appendix E National Trail Surface Study Survey
Appendix E National Trail Surface Study Survey...
-
20. Does topping off a play surface trigger its replacement with an accessible surface?
Does topping off a play surface trigger its replacement with an accessible surface? No....
-
Qualitative Analysis by Surface Type
Qualitative Analysis by Surface Type The observational data collected through the visual inspections of the sites and discussions with the playground owners provided invaluable lessons...
-
4.33.4 Surfaces
The ground or floor at wheelchair locations shall be level and shall comply with 4.5.
-
4.33.4 SURFACES
The ground or floor at wheelchair locations shall be level and shall comply with 4.5.
-
Accessible Surfaces Located In The Use Zone
Accessible Surfaces Located In The Use Zone If located within the use zone, accessible ground surfaces must also be impact attenuating and meet ASTM F 1292-04 Standard Specification for...
-
3.4.6 Surface
The surface of each viewing area shall be firm and stable. The type of surface should be appropriate to the setting and level of development. ...
-
Surface and Slope [1012.4 and 1012.5]
The technical requirements for the surface and slope of parking spaces for vehicles other than RVs are the same as for RV parking spaces....
-
1014.3.1 Surface
The floor surface shall be firm and stable....
-
1014.3.1 Surface
The floor surface shall be firm and stable....
-
Surface and Size [§305.2 and §305.3]
Surface and Size [§305.2 and §305.3] Clear floor spaces must meet requirements for ground and floor surfaces, including criteria for firmness, stability, and slip resistance....