Search Results "Work Area Equipment"

• Federal Documents > Regulations > 28 CFR Part 36 Nondiscrimination on the Basis of Disability by Public Accommodations and in Commercial Facilities (2010 ADA Title III Regulations with amendments issued through Dec. 2016)
  § 36.308 Seating in assembly areas.

  A public accommodation shall ensure that wheelchair spaces and companion seats are provided in each specialty seating area that provides spectators with distinct services or amenities that...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302

  The Access Board proposed in M101.2 in the MDE NPRM to require diagnostic equipment to meet the standards for each patient position supported, meaning that if diagnostic equipment was designed...

• State and Local Documents > Referenced Standards > Excerpts from 2000 INTERNATIONAL BUILDING CODE®
  1003.2.13.1 General

  Where the exit discharge is not accessible, an exterior area for assisted rescue must be provided in accordance with Section 1003.2.13.7. 2....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Federal Documents > Technical Assistance > Access to Medical Care for Individuals with Mobility Disabilities
  PART 1: OVERVIEW AND GENERAL REQUIREMENTS

  Accessibility of doctors’ offices, clinics, and other health care providers is essential in providing medical care to people with disabilities. Due to barriers, individuals with...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope Recommendations

  5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height

  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  M301.3.2 Stirrups

  M301.3.2 Stirrups Proposed requirement: Where stirrups are provided, they shall provide a method of supporting, positioning, and securing the patient’s legs. • Sub-committee...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations

  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope

  5.8.1.2.1 Ramped Entry Slope. Raised platforms should have a ramp with slopes that do not exceed the following: Rise 0 to 1 ½ inches – 1:2 Slope Rise >1 ½ to 2 ½ inches – 1:8...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides

  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides. A minimum 2 inch high edge protection must be provided on both sides of the platform for double ramped entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides

  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides. A 2 inch high edge protection must be provided on the back of the platform, opposite the entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations

  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations The Committee recommends that no edge protection be required on platforms of 1½ inches or less...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations

  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations The Committee recommends a minimum two-inch high edge protection on both sides of the...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M305.3.1 Horizontal Position

  Where the support is horizontal, the top of the gripping surface shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum above the standing surface. The gripping surface...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.2.5 Surfaces

  Wheelchair space surfaces shall not slope more than 1:48 in any direction.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3.4 Edge Protection

  Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.2.5 Surfaces

  Wheelchair space surfaces shall not slope more than 1:48 in any direction.

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  4.1.6(3)(f)(ii)

  (ii) Where it is technically infeasible to alter all performing areas to be on an accessible route, at least one of each type of performing area shall be made accessible....

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  4.1.3(9)*

  Areas of rescue assistance shall comply with 4.3.11....

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  1007.1 Accessible means of egress required

  In assembly areas with sloped or stepped aisles, one accessible means of egress is permitted where the common path of travel is accessible and meets the requirements in Section 1028.8, and...