For example, alterations to floors above or below the accessible ground floor must be accessible regardless of whether the altered facility has an elevator....
Search Results "Practice Teeing Ground"
-
Sec.36.404(b)
-
2.7 Tread Obstacles
Where the surface is paved or is elevated above the natural ground, obstacles shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point. ...
-
4.3.3 Slope
When the surface is not paved or is not elevated above the natural ground, slopes not steeper than 1:33 (3 percent) shall be permitted where necessary for drainage. ...
-
1013.3 Slope
This section requires the slope of the surface of tent pads, tent platforms, and clear ground spaces to not be steeper than 1:48 in any direction....
-
11B-203.14 Raised diving boards and diving platforms
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
-
11B-605.2 Height and depth
Urinals shall be the stall-type or the wall-hung type with the rim 17 inches (432 mm) maximum above the finish floor or ground....
-
11B.707.7.1.3 Horizontally mounted display screen
viewer 60 degrees to 90 degrees (horizontal) from vertical, the center line of the display screen and other display devices shall be no more than 34 inches (864 mm) above the floor or ground...
-
11B-203.14 Raised diving boards and diving platforms
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
-
308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1220 mm) maximum and the low forward reach shall be 15 inches (380 mm) minimum above the finish floor or ground...
-
306.3.4 Clearance Reduction
Between 9 inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
803.5 Coat Hooks and Shelves
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
Gamco Welded Frame Mirrors - A-Series
Corners are welded and ground smooth. Back Panel - fabricated of galvanized steel with tab lock and snap lock design slots formed to receive wall hanger tabs....
-
CHG Hospital Beds Spirit Select
Spirit Select is loaded with regular hospital bed features, and it has the ability to go lower to the ground than any other hospital bed on the market....
-
R202.3.1 Existing Physical Constraints
physical constraints make it impracticable for altered elements, spaces, or facilities to fully comply with the requirements for new construction, compliance is required to the extent practicable...
-
§ 36.311(b) Other power-driven mobility devices
A public accommodation shall make reasonable modifications in its policies, practices, and procedures to permit the use of other power-driven mobility devices by individuals with disabilities...
-
12182(b)(3) Specific construction
The term "direct threat" means a significant risk to the health or safety of others that cannot be eliminated by a modification of policies, practices, or procedures or by the provision...
-
§ 35.138(a) General
A public entity that sells tickets on a preassigned basis shall modify its policies, practices, or procedures to ensure that individuals with disabilities can purchase tickets for accessible...
-
Staff Training
It is always a good practice to involve people who are blind or who have low vision in the development of your training programs....
-
10.3.1(6)
All signs referenced in this paragraph shall, to the maximum extent practicable, be placed in uniform locations within the transit system....
-
10.3.1(15)
Clocks shall be placed in uniform locations throughout the facility and system to the maximum extent practicable....
-
10.4.1(7)
Clocks shall be placed in uniform locations throughout the facility to the maximum extent practicable....
-
§ 37.5(i)(2) Private entity-public transport
Private entities that provide specified public transportation shall make reasonable modifications in policies, practices, or procedures, when the modifications are necessary to afford goods...
-
§ 37.5(i)(3) Public entity-public transport
Public entities that provide designated public transportation shall make reasonable modifications in policies, practices, or procedures when the modifications are necessary to avoid discrimination...
-
2010 ADA Standards
It is good practice when specifying dimensions to avoid specifying a tolerance where dimensions are absolute....
