For vehicles in excess of 22 feet in length, the overhead clearance between the top of the door opening and the raised lift platform, or highest point of a ramp, shall be a minimum of 68...
Search Results "Curb Ramp Bottom Landing"
-
§ 38.25(c) Door height
-
Door and Signal Timing
Destination-oriented elevators may have call buttons located outside elevator landing areas and have enhanced programming features for the response time of cars....
-
11B-410.6 Doors and gates
Exception: Platform lifts serving two landings maximum and having doors or gates on opposite sides shall be permitted to have self-closing manual doors or gates....
-
11B-410.6 Doors and gates
Exception: Platform lifts serving two landings maximum and having doors or gates on opposite sides shall be permitted to have self-closing manual doors or gates....
-
Swimming pools, wading pools, saunas, and steam rooms. (Section-by-Section Analysis)
The commenters pointed out that existing wave pools often have a sloped entry, but do not have the handrails, level landings, or edge protection required for accessible entry....
-
502.2 Vehicle Spaces
See section 406.5 curb ramp location....
-
R305.2 Placement
Where the back of curb edge is tooled to provide a radius, the border dimension should be measured from the end of the radius....
-
Reach Range
The Board has included an exception for bottom-hinged appliance doors, which do not have to be within reach range requirements specified in 309.3 when open (804.6.2, Exception 2)....
-
11B-404.2.11 Vision lights
Doors, gates, and side lights adjacent to doors or gates, containing one or more glazing panels that permit viewing through the panels shall have the bottom of at least one glazed panel...
-
M305.3.2 Height (Section-by-Section Analysis)
For vertical supports, the MDE NPRM proposed that the bottom end of the support be 34 inches high minimum and 37 inches high maximum above the standing surface....
-
Running Slope [1016.7.1]
To accommodate steep terrain, ORARs may be designed with shorter sections that have a steeper running slope and length, as shown in table 3, with resting intervals at the top and bottom...
-
1132A.9 Smooth surface
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal....
-
Mirrors [4.19.6]
The mounting height of the bottom of mirrors at accessible lavatories (40 inches maximum above the floor) is based on the standard eye level range of adults seated in wheelchairs (43 to...
-
4.34.6.7* OVENS
Bottom-hinged door...
-
Bathtub
As a result, grab bars that would permit older adults to raise and lower themselves from the bottom of the tub were not included in bathtub designs....
- Sargent AD8400 & NB-AD8400 Narrow Stile Concealed Vertical Rod Exit Device
-
Cane detectable barriers at stand pipes in stair ways
Does anyone have photos of cane detectable barriers that you have seen/used around the stand pipes and fire risers which are installed in corner landings of stair wells?...
-
Original research for ANSI A117.1 (1957 - 1961)
In the original research for ANSI A117.1 - 1961, American National Standard Specifications for Making Buildings and Facilities Accessible to, and Usable by, the Physically Handicapped, ramps...
-
Appendix B Trails Study Participation Press Release
Appendix B Trails Study Participation Press Release National Center on Accessibility National Trails Surface Study Press Release NCA Seeks Land Managers with Trails to Participate...
- Increasing Opportunities for Access on the Appalachian Trail: A Design Guide
-
Alterations
An accessible path of travel may consist of walkways, parking access aisles, curb ramps, regular ramps, doorways, paths through lobbies and corridors, elevators and lifts....
-
RESULTS OF OBJECTIVE SURFACE MEASUREMENT
The work to negotiate a ramp was linearly related to the angle of the ramp....