This section requires the slope of the surface of parking spaces and pull-up spaces to not be steeper than 1:48 in any direction....
Search Results "Hybrid Surface System"
Commonly Searched Documents
-
1012.5 Slope
-
Passenger Loading Zones [4.6.6]
A level surface (maximum 2% slope in any direction) for both the space and aisle is important for wheelchair transfer to and from vehicles and deployment of vehicle lifts or ramps....
-
1014.3 Floor
The floor within camp shelters shall comply with 1014.3.
-
R304.5.3 Cross Slope
R304.5.3 Cross Slope. The cross slope of curb ramps, blended transitions, and turning spaces shall be 2 percent maximum. At pedestrian street crossings without yield or stop control...
-
Addendum F: Relative Height Differences
Relative heights were calculated for high and low transfers for all three protocols. Refer to Addendum A for the definition of relative height. The following tables F1-F3 represent...
-
1133A.4.1, Item 3
3. The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent...
-
1014.3 Floor
The floor within camp shelters shall comply with 1014.3.
-
1.1.12 Ramp cross slope
1.1.12 Ramp cross slope. Measure for overall cross slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the...
-
1133A.4.1, Item 3
3. The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent...
-
11B-205.1 General
In residential dwelling units with mobility features where receptacles are provided in a kitchen at a corner work surface, one receptacle shall be located 36 inches (915 mm) from either...
-
Moving Beyond “Special Needs” - A Function-Based Framework for Emergency Management and Planning
JOURNAL OF DISABILITY POLICY STUDIES Moving Beyond “Special Needs” A Function-Based Framework for Emergency Management and Planning
- State of Texas Functional Needs Support Services Tool Kit
-
4.8.5* HANDRAILS
(2) If handrails are not continuous, they shall extend at least 12 in (305 mm) beyond the top and bottom of the ramp segment and shall be parallel with the floor or ground surface....
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports....
-
§ 35.151(f)(1)
sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 of the 2010 Standards and kitchen work surfaces...
- Q'Straint : QUANTUM - Complete Wheelchair Securement in 25 Seconds
- Q'Straint : QUANTUM User Experience - A First Hand Account
- Q'Straint : QUANTUM Automatic Rear-Facing Wheelchair Securement Station
- Q'Straint : On Board with the QUANTUM - Automatic Wheelchair Securement
-
Does a wheelchair user have to use the seat belt and shoulder harness?
Under the broad nondiscrimination provisions in Section 37.5 of the DOT ADA regulations, a transit operator is not permitted to mandate the use by wheelchair users of seat...
-
Does a wheelchair user have to use the seat belt and shoulder harness?
Under the broad nondiscrimination provisions in Section 37.5 of the DOT ADA regulations, a transit operator is not permitted to mandate the use by wheelchair users of seat belts and...
-
M305.3.1 Horizontal Position
Where the support is horizontal, the top of the gripping surface shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum above the standing surface....
-
Sec.36.303(b)(1)
(1) Qualified interpreters, notetakers, computer-aided transcription services, written materials, telephone handset amplifiers, assistive listening devices, assistive listening systems,...
-
M301.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....