. § 12102).10 The examples of major life activities in the Section 504 regulatory provisions, at 34 C.F.R. § 104.3(j)(2)(ii), predate the Amendments Act, and are not exhaustive....
Search Results "Circular Cross Section"
Filters
Commonly Searched Documents
-
Q6. Does the Amendments Act address the "major life activities" referred to in the Section 504 and Title II regulations?
-
IV. CONCLUSION
For the foregoing conclusions, Plaintiffs' motion for summary judgement is GRANTED and Defendants' cross-motion for summary judgement is DENIED....
-
H.5 - Does an agency have an obligation under Section 508 to address a complaint that is about EIT that was procured before June 21, 2001?
Section 508 does not provide enforcement provisions for EIT that was procured before June 21, 2001....
-
D) Curb Ramps at Intersections
When walkways cross a curb at intersections, a ramp or sloped surface is needed. The title II regulations set requirements for curb ramps at intersections....
-
§ 38.23(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less...
-
§ 38.95(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less...
-
§ 38.125(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less...
-
§ 38.83(b)(13) Handrails
Handrails shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less than...
-
Willoughby Industries ETW-1445-BS-HC Toilet for 45-degree Chase Wall
On back to back fixture installations, do not use standard cross type waste fitting: cross flow may result due to blowout jet action. Use sanitary or offset type waste fittings....
-
Sections 35.108(a)(2) and 36.105(a)(2) Definition of ‘‘disability’’—Rules of Construction
Sections 35.108(a)(2) and 36.105(a)(2) Definition of ‘‘disability’’—Rules of Construction In the NPRM, the Department proposed §§ 35.108(a)(2) and 36.105(a)(2), which set forth rules...
-
Parallel Curb Ramps
A level landing 48” long minimum (60” preferred) accommodates maneuvering between runs and right-angle turns to connecting routes, such as parking access aisles and crossings....
-
R208.2 Where Not Required
Where a cut-through pedestrian refuge island is less than 1.8 m (6.0 ft) in length and the pedestrian street crossing is signalized, the signal should be timed for a complete crossing of...
-
R302.3 Continuous Width
The continuous clear width requirements in R302.3 apply to sidewalks and other pedestrian circulation paths, pedestrian street crossings and at-grade rail crossings, and pedestrian overpasses...
-
Different "Types"
"Rocking" is an example of horizontal movement that can be backwards, forwards, sideways or even circular in nature. ...
-
Section 36.303(g)(7) Compliance Date for Providing Captioning and Audio Description
Department's independent research, the Department agrees that 6 months may be an insufficient amount of time for movie theaters to comply with the requirements of paragraph (g) of this section...
-
Section 36.303(g)(3) Minimum Requirements for Captioning Devices
theaters be required to have available a minimum number of captioning devices equal to approximately half the number of assistive listening receivers already mandated for assembly areas by sections...
-
Comparison of Single-User Toilet Room Layouts: 1A, 1B, and 1C
Features include: five-foot minimum width between the side wall of the water closet and the lavatory; 60-inch minimum circular wheelchair turning space; and 36-inch by 48-inch clear maneuvering...
-
Largely in response to comments, the Board made numerous changes from its proposal, including the following: (Preamble, Section-by-Section Analysis)
Largely in response to comments, the Board made numerous changes from its proposal, including the following:
-
§1193.37 Information pass through.
Telecommunications equipment and customer premises equipment shall pass through cross-manufacturer, non-proprietary, industry-standard codes, translation protocols, formats or other information...
-
221.1 General
Assembly areas shall comply with the provisions applicable to assembly areas, including, but not limited to, sections 221 and 802....
-
Section 37.71 Purchase or Lease of New Non-Rail Vehicles by Public Entities Operating Fixed Route Systems
Section 37.71 Purchase or Lease of New Non-Rail Vehicles by Public Entities Operating Fixed Route Systems This section generally sets out the basic acquisition requirements for a public...
-
Grohe Allure F-digital Basin Mixer Faucet
A square base plate gives rise to the circular control – mirroring the same design details that give Allure faucets their modern appeal....
-
Section 35.151(b)(4)(ii)(C) Path of travel--safe harbor
Section 35.151(b)(4)(ii)(C) Path of travel--safe harbor In Sec. 35.151(b)(4)(ii)(C) of the NPRM, the Department included a provision that stated that public entities that have brought...
-
Section 37.171 Equivalency Requirement for Demand Responsive Service Operated by Private Entities Not Primarily in the Business of Transporting People
Section 37.171 Equivalency Requirement for Demand Responsive Service Operated by Private Entities Not Primarily in the Business of Transporting People This provision is a service requirement...
