Braille (right side up!) Issue 11. Good vibrations (vibrotactile indications) Issue 12. Audible beaconing Issue 13. Stub poles Issue 14....
Search Results "Pull Side"
Commonly Searched Documents
-
Installation Issues
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
To simplify the tolerance assessment, the 2010 Standards specify that the shower compartment be measured at the center points of opposing sides but the expectation is that the width at the...
-
Submerged Depth
Adding a solid wall on the side closest to the water can enhance safety....
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Imaging Equipment
Especially, Section M301, Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position....
-
C. Chapter 3: Technical Requirements (Section-by-Section Analysis)
requirements for accessible medical diagnostic equipment based on how the diagnostic equipment is used by the patients, including: diagnostic equipment used by patients in a supine prone, or side-lying...
-
R306.3 Roundabouts
Pedestrian street crossings at roundabouts can be difficult for pedestrians who are blind or have low vision to identify because the crossings are located off to the side of the pedestrian...
-
Areas of sport activity. (Section-by-Section Analysis)
In court sports, the accessible route would also have to directly connect both sides of the court. ...
-
H29
If a coat hook is provided is it mounted no higher than 54 inches above the floor for a side approach or 48 inches above the floor for a front approach?...
-
1009.4.5 Grab Bars
Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar....
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
1009.5.7 Grab Bars
Grab bars shall comply with 609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-1009.4.5 Grab bars
Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar....
-
Other Safety tips:
Use the “Peep Hole” in the guestroom door to determine who is on the other side before you open the door. [All hotel staff members have uniforms and name tags....
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Floor Plan of Elevator Cars [4.10.9]
Hospital-type cars sized to accommodate stretchers (usually at least 80 inches long) can have side-opening doors if the car is at least 60 inches wide....
-
2.2.1 Demographic Information
Digital photographs of the user and device were taken from the front and side views to document the wheelchair accessories and configurations of WhMD user. Figure 2-1....
-
Pay Stations
Requirements for operable parts include: Clear floor space for a forward or side approach (§309.2) Location within accessible reach ranges (§309.3) One-hand operation...
-
4.5 Maneuvering Clearances
In comparison, the UDI participants utilized a much larger space for the 360 degree turn, in which no sides were blocked....
- Pilot Rock CN-Q/D-32/2 Square Trash Receptacle Expanded Steel
- Inclusion Solutions Poll Star Voting Booth
- Lynx Grills Inc. 36” Grill - 1 ProSear Burner & 2 Stainless Steel Burners (L600ADA)