(5) Identify the persons or groups with whose assistance the plan was prepared....
Search Results "Seating Plan"
-
§8.25(c)(5)
-
§8.21(c)(4)(v)
(v) Identify the persons or groups with whose assistance the plan was prepared....
-
§8.24(d)(5)
(5) Identify the persons or groups with whose assistance the plan was prepared....
-
§ 37.139(c)(1)
(1) An inventory of service provided by the public entity submitting the plan;...
-
§ 37.145(b)
(b) Certify to FTA that all plans have been received....
-
§ 36.302(f)(8)(iii) Investigation of fraud
A public accommodation may investigate the potential misuse of accessible seating where there is good cause to believe that such seating has been purchased fraudulently....
-
§ 36.406(f)(3)
(3) Facilities that have more than 5,000 seats shall provide at least five wheelchair spaces and at least three companion seats for each wheelchair space; and...
-
§ 36.302(f)(5)(i)(B)
(B) When all non-accessible tickets in a designated seating area have been sold and the tickets for accessible seating are being released in the same designated area; or...
-
§ 35.138(h)(3) Investigation of fraud
A public entity may investigate the potential misuse of accessible seating where there is good cause to believe that such seating has been purchased fraudulently....
-
§ 35.138(e)(1)(ii)
(ii) When all non-accessible tickets in a designated seating area have been sold and the tickets for accessible seating are being released in the same designated area; or...
-
4.1.3 Adjustable Height Chairs with and without Footplates
Figure 4.1 shows the chair when configured in an upright seated position; these same patient support surfaces (made up of the back, seat, and leg rests) are repositioned horizontally to...
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
T303 Handrails, Stanchions, and Handholds
We received only one comment on the proposed technical requirements in the 2010 NPRM related to the cross section of seat-back handholds....
-
1.3.1 Overview of NPRM
Position M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair M304 Diagnostic Equipment Used by Patients in Standing Position...
-
903.4 Back Support
Back support shall be 42 inches (1065 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (455 mm) minimum above the seat...
-
Location of Accessible Routes to Stages
The 1991 Standards at section 4.33.5 require an accessible route to connect the accessible seating and the performing area....
-
Is obesity considered a disability under the ACAA?
QUESTION: Is obesity considered a disability under the ACAA and, if so, is an obese passenger entitled to two seats for the price of one if he or she needs more than one seat?...
-
§ 38.23(d)(2) Location and size
Not more than 6 inches of the required clear floor space may be accommodated for footrests under another seat provided there is a minimum of 9 inches from the floor to the lowest part of...
-
903.4 Back Support
Back support shall be 42 inches (1065 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (455 mm) minimum above the seat...
-
You must allow passengers to safely stow their wheelchairs
., wheels, seats, etc.) in the overhead bin or under seats. [Sec. 382.41(e)(1)]...
-
T. Related Entities
corporations, commissioners, officers, employees, agents, representatives, board members, officials, assigns, assignors, attorneys, affiliates, predecessors, successors, employee welfare benefit plans...
-
§ 36.309(b)(1)(v)
modifications, accommodations, or related aids and services provided in response to an Individualized Education Program (IEP) provided under the Individuals with Disabilities Education Act or a plan...
-
Surface
During the planning process, firmness must be evaluated for noticeable distortion or compression during the seasons for which the surface is managed, under normally occurring weather conditions...