Search Results "Boarding Device"
-
Figure 405.9.1 Extended Floor or Ground Surface Edge Protection – Drawing from the U.S. Access Board
-
Figure 604.8.1.4 Wheelchair Accessible Toilet Compartment Toe Clearance – Drawing from the U.S. Access Board
-
Figure 608.3.2 Grab Bars for Standard Roll-In Type Showers – Drawing from the U.S. Access Board
-
Figure 608.2.1 Transfer Type Shower Compartment Size and Clearance – Drawing from the U.S. Access Board
-
Figure 404.2.4.3(c) Maneuvering Clearance at Recessed Doors and Gates – Drawing from the U.S. Access Board
-
Figure 404.2.4.3(b) Maneuvering Clearance at Recessed Doors and Gates – Drawing from the U.S. Access Board
-
Figure 406.2 Counter Slope of Surface Adjacent to Curb Ramps – Drawing from the U.S. Access Board
-
Figure 609.2.2 Grab Bar Non-Circular Cross Section – Drawing from the U.S. Access Board
-
Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers – Drawing from the U.S. Access Board
-
Figure 1003.3.1 (Exception 2) Edge Protection at Boat Slips – Drawing from the U.S. Access Board
-
Figure 608.5.1 Transfer Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
Paragraph (e) Availability of auditory information for people who are hard of hearing (Section-by-Section Analysis)
., Director, Rehabilitation Engineering and Research Center on Hearing Enhancement and Assistive Devices, Lexington Center)....
-
Dispersion Requirements
In the proposed rule, the Board posed several questions concerning the requirements for the dispersion of wheelchair spaces (which were located in section 802.6)....
-
Fact Sheet: Highlights of the Final Rule to Amend the Department of Justice's Regulation Implementing Title III of the ADA
Architectural and Transportation Barriers Compliance Board (Access Board)....
-
Shower Threshold
The Board retained the ½ inch threshold height since positioning for transfer to the seat of transfer showers can be aided where a close approach enables footrests to clear the threshold...
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
NPRM Preamble Discussion: The Access Board is considering whether 1½ inches minimum clearance around the gripping surface would be appropriate for transfer supports on diagnostic equipment...
-
Skateboards
Each set of wheels is attached to the platform with a pivoting "truck," which allows the board to turn when the user leans his or her body and/or feet....
-
902 Dining Surfaces and Work Surfaces
Commenters expressed concern about use of the terms "dining surfaces" and "work surfaces" and urged the Board to include definitions of the terms in the final rule....
-
M303.2.3 Depth (Section-by-Section Analysis)
In the preamble in the MDE NPRM, the Access Board noted it was considering increasing the minimum depth for wheelchair spaces entered from the front or rear to 58 inches and sought input...
-
1009.3 Sloped Entries
Personal wheelchairs and mobility devices may not be appropriate for submerging in water....
-
USE OF THE WAY
Elevators are required to have both a telephone and an emergency signaling device....
-
Human Subject Testing
Subjects were recruited by gender and mobility limitation (no known disability, ambulatory with limited mobility, ambulatory with assistive devices, and manual wheelchair use)....
-
Small entities potentially affected by proposed standards
The proposed standards do not impose any mandatory requirements on health care providers or medical device manufacturers....
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
