The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
Search Results "Surface Material"
Filters
Commonly Searched Documents
-
11B-904.3.2 Counter
-
Trailhead Information Signs [F216.13 and 1017.10]
When this information is available on Web sites and in printed materials, it allows all hikers, including people with disabilities, the opportunity to understand the possible challenges...
-
ADA Standards for Accessible Design Pocket Guide: ADA Standard Section 2010
The complete guide to the 2010 ADA Standards for Accessible Design with notes provided by national accessibility experts Evan Terry Associates
-
1.1.3.2, Item 14.4
Hazardous materials, flammable and combustible liquids...
-
Bradley MG Terreon Waste Receptacle
Compatible with Express Lavatory Systems - MG-Series Cover is constructed of vandal-resistant Terreon or TerreonRE Solid Surface Material, available in dozens of colors...
-
CURB RAMP
[DSA-AC] A sloping prepared surface, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
§ 38.23(b)(1) Design load
pulleys, and shafts, which can be expected to wear, and upon which the lift depends for support of the load, shall have a safety factor of at least six, based on the ultimate strength of the material...
-
§ 38.95(b)(1) Design load
pulleys, and shafts, which can be expected to wear, and upon which the lift depends for support of the load, shall have a safety factor of at least six, based on the ultimate strength of the material...
-
§ 38.125(b)(1) Design load
pulleys, and shafts, which can be expected to wear, and upon which the lift depends for support of the load, shall have a safety factor of at least six, based on the ultimate strength of the material...
-
§ 38.83(b)(1) Design Load
pulleys, and shafts, which can be expected to wear, and upon which the lift depends for support of the load, shall have a safety factor of at least six, based on the ultimate strength of the material...
-
Accessibility - Flatness and Lippage
Setting Bed Materials Joint Widths Construction Tolerances Sand setting beds for concrete pavers and paving slabs Joint width between adjacent units (See Figure...
-
II. LEGAL STANDARD
Summary judgment is only appropriate where the “materials in the record, including depositions, documents, electronically stored information, affidavits or declarations, stipulations (including...
-
FAQ: Why should I enter ADA references in my Voices post?
When you enter relevant ADA references in your Voices post, the post is integrated with Corada’s existing database of other accessibility-related material, so your question, comment, Opinion...
-
23.1 Q. What type of reinforcement should be used to reinforce bathroom walls for the later installation of grab bars?
The Guidelines do not prescribe the type of material to use or method of providing reinforcement for bathroom walls....
-
§ 38.159(b)(1) Design load
pulleys, and shafts, which can be expected to wear, and upon which the lift depends for support of the load, shall have a safety factor of at least six, based on the ultimate strength of the material...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Confidential
Confidential Conversations and materials produced during the mediation sessions are confidential....
-
American Specialties Single-Roll Surface Mounted Toilet Paper Holder 7305
Type 304 bright finish stainless steel with chrome-plated roller. Heavy gauge concealed bracket mounts on wall secured with stainless steel set screw. Holds 1800 sheet standard core...
-
Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.230V
Durable, 22-gauge, zinc-plated steel with white epoxy cover with black plastic trim, automatic sensor, dual air outlets, 208-240V AC, 6.8-7.8 Amp, 1400-1900 Watts, 50/60 Hz, Single...
-
Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.115V
Durable, 22-gauge, zinc-plated steel with white epoxy cover with black plastic trim, automatic sensor, dual air outlets, 115V AC, 15 Amp, 1725 Watts, 50/60 Hz, Single Phase, UL...
-
AJW Architectural Products U190 Series Singlefold Towel Dispenser - Surface Mounted
Product Features Holds 400 single fold towels Fabricated of #22 gauge stainless steel with a #4 satin finish Secured with pin tumbler lock, keyed like all AJW...
-
Bobrick Surface-Mounted Multi-Roll Toilet Tissue Dispenser B-2888
Satin-finish stainless steel unit with stainless steel dispensing mechanism. Door has flat face with protruding tumbler lock. Holds two rolls up to 5 1⁄4" (135mm) diameter (1800...
-
Norton Surface Mounted Series 5600 Hands-Free Door Operation Kits
The NORTON 5600 Series Hands-Free Kits combine a wave-to-open switch with the 5600 power operator to open the door and provide a ‘clean’ exit without touching hardware. However,...
-
Gamco Surface Mounted Multi-Roll Toilet Tissue Dispenser - TTD-5
Description Satin-finish stainless steel. Door has tumbler lock. Holds two standard core toilet tissue rolls up to 5 1/4" (135mm) diameter. Extra toilet tissue roll automatically...
