A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum shall be provided....
Search Results "Reflecting Surface"
Filters
Commonly Searched Documents
-
11B-904.4.2 Forward approach
-
11B-1009.2.4 Seat
The height of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the...
-
Trailhead Information Signs [F216.13 and 1017.10]
The new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread...
-
Accessibility - Flatness and Lippage
Accessibility - Flatness and Lippage: With regard to flatness, the amount of substrate variation generally is reflected in the finished tile installation....
-
Executive Summary
Mitigation of glare from daylight through windows and other openings, from artificial lighting fixtures, surface reflections, etc. iv....
-
Elongated surface openings must be perpendicular to the dominant direction of travel, but what if there is no dominant direction of travel?
When there is no dominant direction of cross traffic, openings must be limited to ½” in both dimensions. Where space allows accessible routes to completely bypass the area with...
-
Transfer Height: ADA Standard Section 1002.5.2
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
11B-1002.5.2 Transfer height
The height of amusement ride seats designed for transfer shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
Water Closets and Toilet Compartments for Children's Use: ADA Standard Section 604.9
Section 604.9 covers the current ADA Standards for water closets and toilet compartments for children's use.
-
F206.7.5 Existing Site Constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
206.7.5 Existing Site Constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
11B-1009.3.1 Sloped entries
Exception: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
R409.4 Height
Top of gripping surfaces of handrails shall be 865 mm (2.8 ft) minimum and 965 mm (3.2 ft) maximum vertically above walking surfaces, ramp surfaces, and stair nosings....
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
Rejected this after installation. The design of the hand hold is completely sloped at about 45 degrees. My fingers slipped off unless I applied tremendous pinching force to operate....
-
11B-809.12 Electrical receptacles, controls and switches
When the reach is over a kitchen work surface and base cabinet, the work surface shall be 36 inches (914 mm) maximum above the finish floor and 25 1/2 inches (650 mm) maximum in depth....
-
Curb or Barrier: ADA Standard Section 405.9.2
Section 405.9.2 covers the current ADA Standards for a curb or barrier that is provided as edge protection at a ramp.
-
Abstract
The purpose of the longitudinal surface study was to evaluate a variety of trail surface materials, and their ability to meet proposed accessibility requirements of firmness and stability...
-
Manual vs. Power (RMS Values)
Power wheelchair The last section demonstrated that the vibration data for the engineered surfaces are much more consistent than the outside surfaces....
-
206.7.5 Existing Site Constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
11B-206.7.5 Existing site constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
Section 1630.16(c) Drug Testing
Section 1630.16(c) Drug Testing This provision reflects title I's neutrality toward testing for the illegal use of drugs....
-
RELIEF TO THE COMPLAINANT
permanently purge from the Complainant’s transcript any reference to the course from which he had to withdraw during Spring Quarter 2012 (including any “withdrawal” designation currently reflected...
-
Advisory Committee on Increasing Competitive Integrated Employment for Individuals with Disabilities
Reflecting the movement toward an “Employment First” philosophy, this committee is charged with making recommendations to the Secretary of Labor on ways to increase opportunities for competitive...
-
11B-206.7.5 Existing site constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....