Section 36.310 Transportation Provided by Public Accommodations (Section-By-Section Analysis and Response to Comments) Section 36.310 contains specific provisions relating to...
Search Results "Elevator Car Position Indicator"
Commonly Searched Documents
-
Section 36.310 Transportation Provided by Public Accommodations (Section-By-Section Analysis and Response to Comments)
-
11B-208 Parking spaces.
[See subsections ...]
-
11B-208 Parking spaces
[See subsections ...]
-
Do the exceptions for accessible routes between stories apply to facilities that are only partially occupied by entities not permitted the exception, such as health care facility or shopping center?
Accessible routes between stories are not required in private sector facilities that are either less than 3 stories or that have less than 3,000 square feet per story excluding the...
-
12165(b) Rail passenger cars
(b) Rail passenger cars If final regulations have not been issued pursuant to section 12164 of this title, a person shall be considered to have complied with the requirements of section...
-
14. Common-use spaces and facilities
Common-use spaces and facilities (including swimming pools, playgrounds, entrances, rental offices, lobbies, elevators, mailbox areas, lounges, halls and corridors, and the like.) 4.1...
-
1003.2.13.1 General.
Elevators complying with Section 1003.2.13.3. Platform lifts complying with Section 1003.2.13.4. Horizontal exits. Smoke barriers....
-
Accessibility Standards in Title II Regulations Issued by DOJ
All references in this notice to the “elevator exemption” in connection with the 1991 Standards refer to the exemption from these specific sections of the 1991 Standards....
-
11B-609.4 Position of grab bars
11B-609.4 Position of grab bars....
- TownSteel MS Series, Grade 1 Escutcheon, with Indicator Mortise Locks
- TownSteel MS Series, Grade 1 Sectional, with Indicator Mortise Locks
-
Elevated Dune Crossings
An dune crossing that is elevated or has a slope that exceeds 1:20 (5 percent) that is part of a beach access route must have handrails and edge protection (figure 118)....
- PlayLSI Elevated Sand Table Play Component
-
Relative positions of the buildings on the National Mall
Relative positions of the buildings on the National Mall Several people suggested ways to communicate how the monuments are positioned in relation to one another....
-
Washing Machines; Clothes Dryers— Sections 214.2 and 214.3 of the 2010 Standards
These requirements apply to each laundry room except that HUD’s Section 504 regulation and UFAS would not require a laundry room on an upper story of a non-elevator building to be accessible...
-
1007.2 Continuity and components
Elevators complying with Section 1007.4. Platform lifts complying with Section 1007.5. Horizontal exits. Smoke barriers....
-
Standards Applicable Prior to March 15, 2012
policy, we will also continue to interpret 34 CFR 104.23(c), which addresses UFAS and departures from UFAS, to permit, but not require, recipients to use the 1991 Standards without the elevator...
-
Hoistway Signs: ADA Standard Section 407.2.3
Section 407.2.3 covers the current ADA Standards for elevator hoistway signs.
- Bobrick Angle-Frame Two Position Tilt Mirror B-294 1630
-
Stages.
If the witness with a mobility disability testifies from a floor level position, the witness could be placed at a disadvantage in communicating with the judge and jury who may no longer...
-
§ 38.85 Between-car barriers
vehicles operate in a high-platform, level-boarding mode, devices or systems shall be provided to prevent, deter or warn individuals from inadvertently stepping off the platform between cars...
-
Problem One (Lifts and Elevators)
Problem One: The elevator or lift to the voting area requires a key to be inserted before the elevator or lift is operational....
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except...