buildings equipped throughout with an automatic sprinkler system installed in accordance with Section 903.3.1.1 or 903.3.1.2, the elevator shall not be required on floors provided with a ramp...
Search Results "Aisle Ramp"
-
1009.2.1 Elevators required
-
11B-108 Maintenance of accessible features
It is not sufficient to provide features such as accessible routes, parking, elevators, ramps or signage if those features are not maintained in a manner that enables individuals with disabilities...
-
Harmar CPL400P Portable Vertical Platform Lift
Features Constant Pressure Paddle Switch with Emergency Stop 4 Removable Caster Wheels Automatic Folding Ramp Platform Gate on Exit Side 36" x 54...
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level ...
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
Blind was a member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps...
-
R302.6 Cross Slope
Cross slope requirements are contained in R304.5.3 for curb ramps and blended transitions, and in R407.3 for ramps....
-
Slope [4.3.7]
Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage....
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
907.5.2.3 Visible alarms
Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps. 3....
-
[F] 907.5.2.3 Visible alarms
Visible alarm notification appliances shall not be required in enclosed exit stairways, enclosed exit ramps, exterior exit stairs and exterior exit ramps....
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or Other Mobility Devices
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters, or Other Mobility Devices
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
11B-226.1 General
Check writing surfaces provided at check-out aisles not required to comply with Section 11B-904.3 shall not be required to comply with Section 11B-902....
-
B8. Accessible Route
Does an accessible route connect the curb ramp to the accessible entrance? [ADA Stds 4.1.2(1)]...
-
Suggestion by Eldon Tipping
Eldon Tipping As published in Concrete Construction magazine, September 1998, Eldon Tipping made suggestions for a specification for sloped random - traffic floors such as parking decks, ramps...
-
Architectural Barriers
narrow to accommodate people who use wheelchairs; a step or steps at the entrance or to part of the selling space of a store; round doorknobs or door hardware that is difficult to grasp; aisles...
-
11B-504.4.1 Contrasting stripe
It should be noted that CBC Chapter 10 has a different requirement for contrasting stripes at stepped aisles in Assembly occupancies (not adopted by DSA-AC, as this is a life safety requirement...
-
4. Grievance Procedure
Curb ramp requests submitted through the City's grievance procedure trigger an investigation by DPW....
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). FIGURE 11B-303.3 BEVELED CHANGE IN LEVEL...
-
T503.5 Exterior Illumination for Boarding and Alighting Areas
Where doorways have ramps, bridgeplates or lifts, the illumination shall be 1 foot-candle (11 lux) minimum for a distance of 3 feet (915 mm) measured beyond the edge of the ramp, bridgeplate...
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level...
-
6.10
sight comparable to those for members of the general public, and (b) include wheelchair spaces as an integral part of the fixed seating plan, (c) provide the appropriate depth for cross aisles...
