Section 240.1.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for additions to play areas.
Search Results "Side Transfer"
Commonly Searched Documents
-
Additions: ADA Standard Section 240.1.1
-
11B-240.2.2 Elevated play components
For purposes of this section, ramps, transfer systems, steps, decks, and roofs are not considered elevated play components....
-
Aisle Seats
The proposed rule required that such seats have removable or folding armrests or no armrests on the aisle side....
-
1007.7.4 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
Water Closet Location and Rear Grab Bar
The 1991 Standards contain no exception for grab bar length, and require the water closet centerline to be exactly 18 inches from the side wall, while the 2010 Standards requirement allows...
-
308.1 General
These dimensions apply to either forward or side reaches....
-
308.1 General
These dimensions apply to either forward or side reaches....
-
Temporary Solutions For Emergency Sheltering - Protruding Object Hazards
Temporary Solutions For Emergency Sheltering - Protruding Object Hazards Problem: Objects protrude too far from the side into the route causing a hazard for people who are blind or who...
-
308.1 General
These dimensions apply to either forward or side reaches....
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
-
Hand Cycles (Stand-Alone)
Additional support, as required, is provided by small caster wheels that are mounted on each side just behind the seat....
-
Error/Omission: Adequate maneuvering clearance is not provided at doors, including doors to accessible toilet stalls.
If toilet stall approach is from the latch side of the stall door, clearance between the door side of the stall and any obstruction may be reduced to a minimum of 42 in (1065 mm) (Fig. 30...
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
-
1015.3 Height
Exceptions: For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, guards on the open sides of stairs shall have a height not less than 34...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
- Spectrum Aquatics Aspen Pool Lift
-
K4
, drink, condiment, and tableware dispensers are provided, are dispensers and operating controls mounted no higher than 54 inches above the floor if clear floor space is provided for a side...
-
Jamb Signage
...are all elevator jambs provided with signs placed on both sides designating the floor with 2" minimum height raised letters and Braille characters centered at 60" above the finish floor...
-
I1a
For a side approach (clear floor space at least 30 inches long x 48 inches wide), is the coin slot no higher than 54 inches above the floor?...
-
4.17.4 Toe Clearances
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....
-
5e.
Are signs mounted on both sides of the elevator hoistway door opening that designate the floor with 2-inch minimum-height raised letters and Braille characters centered at 60 inches above...
-
Assembly Areas
where they adjoin seating and since accessible routes are required to connect to wheelchair seating locations, compliance with 4.9, including requirements for handrails, is not required at sides...
-
4.17.4 TOE CLEARANCES
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....