deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
Search Results "Individual Building Test"
Commonly Searched Documents
-
§ 38.95(b)(9) Platform deflection
-
§ 38.83(b)(9) Platform deflection
deflect more than 3 degrees (exclusive of vehicle roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.23(b)(9) Platform deflection
more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
§ 38.125(b)(9) Platform deflection
not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
- Kee Safety Inc. ADA Safety Handrail Components
-
Existing Site Constraints: ADA Standard Section 206.7.5
Section 206.5.1 covers scoping requirements in the most current ADA Standards for the use of platform lifts due to existing site constraints.
-
711.4.2 Membrane penetrations
Such penetrations shall not exceed an aggregate area of 100 square inches (64 500 mm2) in any 100 square feet (9.3 m2) of ceiling area in assemblies tested without penetrations....
-
Treatment of Data
Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
-
Suggestion by Eldon Tipping
Tipping suggested that each ramp should be evaluated independently as a Random - Traffic Test Surface....
-
Acceptable SEWF Systems
Preliminary portable impact tests provided an indication of the cushioning performance of the stabilizing binder....
-
Appendix C Rotational Penetrometer Data Form
Beneficial Designs Serial num-ber: BDRP- Date of last calibration: Tire pressure set at 36 psi on (date): By: Date & Test...
-
Selection of Locations
The 11 test plots were installed in a previously undisturbed wetlands area where the maximum running slope of any of the sections was 7.6 percent....
- University of Michigan Transportation Research Institute
-
1028.5 Access to a public way
For other than Group E buildings, the area shall be located on the same lot not less than 50 feet (15 240 mm) away from the building requiring egress....
-
11B-233.3.2 Residential dwelling units for sale
Residential dwelling units designed and constructed or altered by public entities that will be offered for sale to individuals shall provide accessible features to the extent required by...
-
11B-233.3.2 Residential dwelling units for sale
Residential dwelling units designed and constructed or altered by public entities that will be offered for sale to individuals shall provide accessible features to the extent required by...
-
11B-233.3.2 Residential dwelling units for sale
Residential dwelling units designed and constructed or altered by public entities that will be offered for sale to individuals shall provide accessible features to the extent required by...
- Apex Challenge Circuit CH7000
-
ALTERATION
[DSA-AC] A change, addition or modification in construction, change in occupancy or use, or structural repair to an existing building or facility....
-
Section 1630.2(j)(4) Condition, Manner, or Duration
According to Congress: “We particularly believe that this test, which articulated an analysis that considered whether a person's activities are limited in condition, duration and manner,...
- Department of Labor, OFCCP Checklist for Compliance with Section 503
-
11B-206.7.5 Existing site constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
§382.133(f)(2)
(2) Any applicable requirement for a manufacturer-affixed label to reflect that the device has been tested to meet requirements for medical portable electronic devices set by the FAA for...
-
711.2 Installation details
Insulation and coverings on or in the penetrating item shall not penetrate the assembly unless the specific material used has been tested as part of the assembly in accordance with this...