3 [§ 4.3.7] The cross slope of the curb ramp is perpendicular to the running slope. Unlike the running slope, which runs along the ramp, the cross slope is measured across the ramp....
Search Results "Perpendicular Curb Ramp"
Filters
Commonly Searched Documents
-
3 [§ 4.3.7]
-
4.1.6(3)(a) Ramps
(a) Ramps: Curb ramps and interior or exterior ramps to be constructed on sites or in existing buildings or facilities where space limitations prohibit the use of a 1:12 slope or less may...
-
4.7.9 Location at Marked Crossings
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). ...
-
4.7.9 LOCATION AT MARKED CROSSINGS
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). Figure 15 Curb Ramps at Marked Crossings...
-
Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis)
on curb ramps....
-
Detectable Warnings [4.7.7]
The edges of curbs can provide a cue to people with vision impairments....
-
C1-e
Where an accessible route crosses a curb, is a curb ramp provided? [ADA Standards § 4.3.8] Yes No...
-
5a. Ramp Surface
Is the ramp surface at least 36 inches wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____...
-
5b. Ramp Slope
Is the slope (up or down the ramp) no more than 1:12? [ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for 12 inches of horizontal distance. Yes _____ No _____...
-
11B-406.5 Common requirements
Curb ramps and blended transitions shall comply with Section 11B-406.5....
-
11B-406.5 Common requirements
Curb ramps and blended transitions shall comply with Section 11B-406.5....
-
11B-406.5 Common requirements
Curb ramps and blended transitions shall comply with Section 11B-406.5....
-
R304.5 Common Requirements
Curb ramps and blended transitions shall comply with R304.5....
-
FACTS APPLICABLE TO ALL CLAIMS
For example, thousands of intersections in the City have no curb ramps or an inadequate number of curb ramps....
-
4 [§ 4.7.2]
4 [§ 4.7.2] The gutter is the part of the street that borders the curb....
-
11B-705.1.2.2.2.2 Two entrance/exit points
perpendicular to the curb, and the turning space shall provide a minimum 36 inches (914 mm) wide portion without detectable warnings to allow pedestrian travel in the direction of the sidewalk...
-
Curb Ramps at Intersections
Curb ramps at marked crossings must be wholly contained within the crosswalk, excluding side flares....
-
R207.2 Alterations
In alterations where existing physical constraints prevent compliance with R207.1, a single diagonal curb ramp shall be permitted to serve both pedestrian street crossings....
-
§35.150(d)(2)
(2) If a public entity has responsibility or authority over streets, roads, or walkways, its transition plan shall include a schedule for providing curb ramps or other sloped areas where...
-
§ 35.150(d)(2)
(2) If a public entity has responsibility or authority over streets, roads, or walkways, its transition plan shall include a schedule for providing curb ramps or other sloped areas where...
-
CURB CUT
[DSA-AC] An interruption of a curb at a pedestrian way, which separates surfaces that are substantially at the same elevation....
-
Section 406.8
maintain the status quo with respect to detectable warnings in pedestrian facilities, the Department is adding a provision (not found in the current version of the new ADAAG) requiring curb...
-
9.b [§ 4.7.5]
9.b [§ 4.7.5] If the sidewalk at the top of the ramp (“x”) is less than 48 inches wide and the curb ramp you are surveying has flared sides, answer this question....