The Access Board was established by section 502 of the Rehabilitation Act of 1973. 29 U.S.C. 792....
Search Results "Level Boarding"
Filters
Commonly Searched Documents
-
The Roles of the Access Board and the Department of Justice
-
Signal Level: ADA Standard Section 407.4.8.2.2
Section 407.4.8.2.2: covers the current ADA Standards for the signal level of audible elevator car indicators.
-
Platform Edges: ADA Standard Section 705.2
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
11B-705.1.2.1 Platform edges
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
Track Crossings: ADA Standard Section 810.10
Where a circulation path serving boarding platforms crosses tracks, it shall comply with 402....
-
2.8 Aircraft and Air Carrier Facility Accessibility.
(See AC 150/5220-21C, Aircraft Boarding Equipment)....
-
Documenting Exceptions and Notifying the U.S. Access Board About Exemptions
Access Board of the determination to exempt the entire trail. Contact information for the U.S. Access Board is available at http://www.access-board.gov/. The U.S....
-
§ 38.73(d) Coordination with boarding platform
(d) Coordination with boarding platform—...
-
408.4.4 Leveling
408.4.4 Leveling. Elevator car leveling shall comply with 407.4.4....
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?...
-
§ 38.95(b)(11) Boarding direction
(11) Boarding direction. The lift shall permit both inboard and outboard facing of wheelchairs and mobility aids....
-
706.6 Peak Clipping Level
706.6 Peak Clipping Level. Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech....
-
Thresholds: ADA Standard Section 404.3.3
Section 404.3.3 covers the current ADA Standards for thresholds at automatic and power-assisted doors and gates.
-
11B-404.3.3 Thresholds
Thresholds and changes in level at doorways shall comply with Section 11B-404.2.5....
-
203.14 Raised Diving Boards and Diving Platforms
203.14 Raised Diving Boards and Diving Platforms. Raised diving boards and diving platforms shall not be required to comply with these requirements or to be on an accessible route....
-
§382.97 To which aircraft does the requirement to provide boarding and deplaning assistance through the use of lifts apply?
The requirement of section 382.95(b) of this part to provide boarding and deplaning assistance through the use of lifts applies with respect to all aircraft with a passenger capacity of...
-
1003.2.2 Boarding Piers at Boat Launch Ramps
1003.2.2 Boarding Piers at Boat Launch Ramps. Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in 1003.2.2. EXCEPTIONS: 1....
-
11B-240.2.1.1 Minimum number and types
Where ground level play components are provided, at least one of each type shall be on an accessible route and shall comply with Section 11B-1008.4....
-
382.65 What are the requirements concerning on-board wheelchairs?
382.65 What are the requirements concerning on-board wheelchairs? These requirements are also patterned on the existing rule....
-
303.3 Beveled
A change in level of ½ inch (13 mm) is permitted to be ¼ inch (6.4 mm) vertical plus ¼ inch (6.4 mm) beveled....
-
§382.57(c)(5)(iv) Tickets and boarding passes
(iv) Tickets and boarding passes....
-
§ 382.57(c)(5)(iv) Tickets and boarding passes
(iv) Tickets and boarding passes....
-
11B-303.3 Beveled
A change in level of ½ inch (13 mm) is permitted to be ¼ inch (6.4 mm) vertical plus ¼ inch (6.4 mm) beveled....
-
303.3 Beveled
A change in level of 1/2 inch (13 mm) is permitted to be ¼ inch (6.4 mm) vertical plus ¼ inch (6.4 mm) beveled....