Some cross slope is necessary to provide drainage and to keep water from ponding and damaging the trail surface, especially on unpaved or natural surfaces....
Search Results "Concrete Surface"
Filters
Commonly Searched Documents
-
Cross Slope [1017.7.2]
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
302 Floor or Ground Surfaces
[See subsections ...]
-
302 Floor or Ground Surfaces
[See subsections ...]
-
A4.5 Ground and Floor Surfaces
[See subsections ...]
-
4.5 Ground and Floor Surfaces
[See subsections ...]
-
A4.5 GROUND AND FLOOR SURFACES.
[See subsections ...]
-
4.5 GROUND AND FLOOR SURFACES
[See subsections ...]
-
R404.2 Surfaces
R404.2 Surfaces....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
404.2.4.4 Floor or Ground Surface
404.2.4.4 Floor or Ground Surface. Floor or ground surface within required maneuvering clearances shall comply with 302. Changes in level are not permitted. EXCEPTIONS: 1....
-
T405.2 Surfaces
Step tread surfaces shall comply with T302....
-
Stabila, Inc. Tech Digital Electronic Level Type 196-2
Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Removable shock-absorbing end caps with anti-slip wall...
-
Stabila, Inc. Magnetic Tech Digital Electronic Level Type 96M-2
Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Rare earth magnets for hands free use / Removable shock-absorbing end...
-
Miracle Sealant Slip-Resistant Flooring Treatment
511 Anti-Slip is a professional grade penetrating sealer designed for the slip-protection of all ceramic tile, porcelain tile, polished marble, polished granite, concrete, masonry and other...
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
R409.6 Gripping Surface
R409.6 Gripping Surface. Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
Loose Fill Surfaces
Loose Fill Surfaces. The predominant surface characteristic is one where many loose particles are combined to create the surface system. ...
-
11B-802.1.1 Floor or ground surface
The floor or ground surface of wheelchair spaces shall comply with Section 11B-302. Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
Performance for Surface Firmness and Stability
Performance for Surface Firmness and Stability In addition to the visual inspection and calculation of the surface deficiency score, the firmness and stability of the surfaces were measured...
-
11B-902.1 General
Dining surfaces and work surfaces shall comply with Sections 11B-902.2 and 11B-902.3....
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
