Where provided, at least one of each type of outdoor constructed features shall comply with 1011....
Search Results "Capital Construction Cost"
Filters
Commonly Searched Documents
-
F244.2.3.1 Outdoor Constructed Features
-
11B-233.3.1 Minimum number: new construction
Newly constructed public housing facilities with residential dwelling units shall comply with Section 11B-233.3.1. [2010 ADAS] 233.3.1 Minimum Number: New Construction. ...
-
3 - Best practices for pre - construction meetings
3 - Best practices for pre - construction meetings Pre - construction meetings provide another commonly used technique to communicate the required needs of the project....
-
11B-233.3.1 Minimum number: new construction
Newly constructed public housing facilities with residential dwelling units shall comply with Section 11B-233.3.1. [2010 ADAS] 233.3.1 Minimum Number: New Construction. ...
-
Trails and Trailheads [F247.3.1 and F247.5]
Within trailheads and along trails, at least 20 percent, but no less than one, of each type of outdoor constructed feature must comply with the applicable technical requirements for the...
-
Construction Specification Institute
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
-
3.5. Installation Costs
Although the Initial RA factored the relevant installation costs into the estimated device costs, the Final RA includes a separate estimation of installation costs. ...
-
101.1 General
The requirements are to be applied during the design, construction, additions to, and alteration of sites, facilities, buildings, and elements to the extent required by regulations issued...
-
III−7.3100 Application (ADAAG §4.1.1(1))
ADAAG applies to all areas in new construction and alterations, except where limited by scoping requirements....
-
Outdoor Constructed Features in Common Use and Public Use Areas [F244.3]
Where outdoor constructed features are provided in common use and public use areas that serve camping units with mobility features, at least 20 percent, but no less than one, of each type...
-
II-6.0000 NEW CONSTRUCTION AND ALTERATIONS
[See subsections ...]
-
§ 36.406 Standards for new construction and alterations.
[See subsections ...]
-
4.0 CONSTRUCTED FEATURES IN RECREATION SITES
[See subsections ...]
-
II-6.0000 NEW CONSTRUCTION AND ALTERATIONS
Regulatory references: 28 CFR 35.151.
-
Trail Construction and Maintenance Notebook
The Missoula Technology and Development Center's "Trail Construction and Maintenance Notebook" contains basic trail building information....
-
F101 Purpose
The requirements are to be applied during the design, construction, addition to, alteration, and lease of sites, facilities, buildings, and elements to the extent required by regulations...
-
11B-202.3.1 Prohibited reduction in access
An alteration that decreases or has the effect of decreasing the accessibility of a building or facility below the requirements for new construction at the time of the alteration is prohibited...
-
11B-233.3.1 Minimum number: new construction
Newly constructed facilities with residential dwelling units shall comply with Section 11B-233.3.1....
-
DSA IR A-10: ALTERATION AND RECONSTRUCTION PROJECTS—DSA APPROVAL EXEMPTION (with revisions issued through Jan. 2018)
IR A-10: ALTERATION AND RECONSTRUCTION PROJECTS—DSA APPROVAL EXEMPTION Disciplines: Structural Fire & Life...
-
68.60. Notice of Substantial Compliance
The Department shall provide a Notice of Substantial Compliance to the owner, at the owner’s request through submission of a Notice of Substantial Compliance Request Form, after a newly constructed...
-
Sec.36.403(f)(2)(iv)
(iv) Costs associated with relocating an inaccessible drinking fountain....
-
§ 36.403(f)(2)(iv)
(iv) Costs associated with relocating an inaccessible drinking fountain....
-
3.2.2.1. Low Accessibility Baseline
The Low Accessibility baseline is the most conservative of the three baselines developed for the cost estimation. ...
-
Laser scanners
Laser scanners use laser beams to automatically develop a three - dimensional image of a space. These types of instruments could be used to measure floor flatness and level but they...