Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
Search Results "Clear Width"
-
Clarification on Standard Roll-In Shower Compliance
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
Depending on the width of the hallway and other circulation issues, it can be preferable to swing the entry door into the toilet room....
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
LaCantina Contemporary Clad Slider System
Panel height may determine max panel width such that the glass does not exceed 60sqft. Color Options LaCantina Doors offer a wide range of in-stock, optional and custom colors....
-
LaCantina Multi-slide Thermally Controlled Aluminum Sliding Door System
Kitchen servery pass through Sizing and Configuration The Aluminum Thermally Controlled system is available in any configuration with panels up to 8' wide and 12' tall, panel width...
-
Transfer Surface Size – M302.2.2 Seated Position
The Subcommittee discussed the width and agreed on a 21 inch minimum width based on anthropometric data and industry human factors experience....
-
4.1 Wheeled Mobility Device Dimensions
Data on occupied device sizes is most valuable for establishing clear floor area requirements....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
T-Shaped Space: ADA Standard Section 304.3.2
Section 304.3.2 covers the current ADA Standards for t-shaped turning space.
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Lateral most point, left (arm, leg, WhMD or accessory) Used to measure Occupied Width....
-
LaCantina Aluminum Wood Slider System
Kitchen servery pass through Sizing and Configuration Options The Aluminum Wood system is available in any configuration with panels up to 8' wide and 12' tall, panel width...
-
LaCantina Multi-slide Aluminum Wood Sliding Door System
combo Kitchen servery pass through Sizing and Configuration The Aluminum Wood system is available in any configuration with panels up to 8' wide and 12' tall, panel width...
-
Length: ADA Standard Section 405.7.3
Section 405.7.3 covers the current ADA Standards for the required length of ramp landings.
-
11B-405.7.3 Length
The landing clear length shall be 60 inches (1524 mm) long minimum....
-
11B-405.7.3 Length
The landing clear length shall be 60 inches (1524 mm) long minimum....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
