Knee and toe clearances are critical where patients seated in a wheelchair need to position their knees and toes next to or underneath a component of the diagnostic equipment....
Search Results "Horizontal Position"
Filters
Commonly Searched Documents
-
5.8.2 Knee and Toe Clearance Recommendations under Breast Platform Recommendations
-
1118B.3
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...
-
Executive summary
Yet, there is no evidence concerning height differences, horizontal distance, and space needed next to the target surface so it can be accessible by a majority of WMD users. ...
-
F - number system
The FL defines the relative conformity of the floor surface to a horizontal plane as measured over a 10 - foot (3.05 m) distance....
-
1134A.5 Bathtubs
Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end a maximum of 6 inches (152.4 mm) from the end walls of the bathtub...
-
Make A Hero - 'The Movement' - Adaptive Sports Film
MAH films create positive awareness of individuals with disabilities, educate the public, and inspire action; each contribution helps sustain this mission....
-
Community Access Center - Riverside, Desert Hot Springs, Menifee, Palm Desert, CA
skills training The primary purpose of Community Access Center is to empower consumers with disabilities by providing services and information to support them in making choices that will positively...
-
Steelcase Series 3 Height-Adjustable Work Surface with Crank
Features: Comfort + Control The simple adjustment of Series 3 allows users to position their work surfaces at the correct height for healthy, efficient computer keying, mousing and...
-
GameTime Roller Table
Children position themselves on the rollers using the slip-resistant starting platform and use the curved overhead handles to move their body along the rollers....
-
NetCentric Technologies Inc. CommonLook PDF Validator Software
Some software has even been known to give false positives or false negatives – passing documents that are not in compliance or failing documents that do, in fact, meet PDF accessibility...
-
9. What type of reasonable accommodations may employees with hearing disabilities need?
The IT specialist position requires frequent one-on-one meetings with the firm's president....
-
II. Recommendations of Diagnostic Imaging Equipment Manufacturers on Transfer Surface Low Height
In some instances, transfer or positioning supports may even be able to provide this assistance, thus maintaining independence of transfer....
-
Section 1630.11 Administration of Tests
Thus, an employer could require that an applicant with dyslexia take a written test for a particular position if the ability to read is the skill the test is designed to measure....
-
11B-604.8.1.2 Doors
compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured perpendicular to the compartment door in its closed position...
-
11B-604.8.1.2 Doors
compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured perpendicular to the compartment door in its closed position...
-
Common Problems with Toilet Rooms
Ø The toilet flush mechanism is positioned on the wrong side of the toilet so that a person sitting in a wheelchair cannot reach it. ...
-
1. When does someone with a hearing impairment have a disability within the meaning of the ADA?
., the major bodily function of special sense organs).[16] A determination of disability must ignore the positive effects of any mitigating measure that is used....
-
11B-404.2.7 Door and gate hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. [Safe Harbor only applies to existing primary entrances.]...
-
Exercise Equipment and Machines
Clear floor space must be positioned to allow a person to transfer from a wheelchair or to use the equipment while seated in a wheelchair....
-
What other surface considerations affect wheelchair travel?
Exterior ramps and walks will generally be constructed with a cross-slope (perpendicular to the direction-of-travel slope) in order to provide positive drainage....
-
Conclusions
., when the table is in a reclined position. Reducing this width to 28 in. would still accommodate 95% of our sample....
-
Notification Forms
In addition to the reason for the exception, documentation should include the date the decision was made and the names and positions of the individuals making the decision....
-
5.7.1.2 Lift Compatibility Clearance in Base for Imaging Equipment (M301)
This type of transfer effectively and safely achieves the patient position needed for the procedure. Below is a picture of an existing CT room with a ceiling mounted overhead lift....
-
20. When an employee requests leave as a reasonable accommodation, may an employer provide an accommodation that requires him/her to remain on the job instead?
The employer is obligated, however, to restore the employee's full duties or to return the employee to his/her original position once s/he no longer needs the reasonable accommodation....
