Spray outlet with 0.5 gpm flow rate. Vandal resistant....
Search Results "Rate of Change"
Commonly Searched Documents
- Symmons SCOT® Slow-Closing Omni Temperature Lavatory Faucet S-60-H
- Corbin Russwin Inc. FE5400S Mult-Point Exit Device Latching System
- Grohe Essence Lavatory Centerset S-Size
- Inpro Corporation JointMaster® 316 Series Single Sightline for Carpet Floor Expansion Joint Covers
- Delta Two Handle Blade Bar/Prep Faucet 2171LF-WBHHDF
- Grohe Grandera Two-Handle Basin Mixer, 1/2" L-Size
- Delta Two Handle Centerset Lavatory Faucet 21C142
- Ultratec Minicom IV TTY
- PDQ 4200 Series Exit Device Door Hardware
- Mockett PCS67 Series Power & USB Bar
- Delta Flush Valve Retrofit Electronic Washdown Urinal Valve DEMD-86405
- Delta Retrofit Electronic Washdown Urinal Valve DEMD-86415
- American Standard Colony PRO Two-Handle Kitchen Faucet with Low-Arc Swivel Spout 7074.500
- Symmetry Vertical Platform Lift VPC-EL
- Federal Elevator 360 Passenger Elevator
- TownSteel CD/CDC Series, Grade 1 Cylindrical Locks
-
[2010 ADAS] 105.2.5 NFPA
the elevator hoistway smoke relief equipment or where required by Chapter 30 of the California Building Code. 12.3.7 (4) Where the vertically run conductors are contained in a 2-hour rated...
-
2.1 Health Care Experiences of Persons with Disabilities
Among women who self-report mobility difficulties, screening rates fall linearly as the severity of mobility limitations increases....
-
Regulatory Process Matters
While this analysis is limited to white collar Federal workers due to data constraints, the potential change in productivity is measured by the difference between the weighted average salary...
-
Amusement rides
It does not apply in cases where the only change to a ride is the theme....
-
General
The Department declines to change the scoping for accessible toilet compartments at this time....
-
708 Two-Way Communication Systems
No further changes have been made to section 708....
-
Maneuvering Clearance or Standby Power for Automatic Doors
The Department declines to change these provisions because they are fundamental life-safety issues....
-
Q2: Milling a Road Surface
existing road, and then overlaying the road with material, regardless of whether it exceeds the height of the road before milling, falls within the definition of “alteration” because it is a change...