[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
Search Results "Standards Development"
Commonly Searched Documents
-
11B-405.2 Slope
-
§382.57(c)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
C. Executive Order 13132: Federalism
The MDE Standards do not impose any mandatory requirements on state and local governments....
-
§27.71(k)(2) Clear floor or ground space.
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§ 27.71(k)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§ 382.57(c)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
V. ACTIONS TO REMEDY NONCOMPLIANCE WITH ACCESSIBILITY REQUIREMENTS
Defendants shall make all architectural modifications in compliance with the ADA and its implementing regulation and the 2010 ADA Standards for Accessible Design (“Standards”). ...
-
Executive Order 13132 (Federalism)
The proposed standards do not impose any mandatory requirements on state and local governments....
- Face® Dipstick® Floor Profiler (Measuring F-Numbers - Concrete Flatness & Levelness Measurement)
-
222 and 803 Dressing, Fitting, and Locker Rooms
The requirements for alterations in the 2010 Standards at section 202.3 do not include the requirement from the 1991 Standards at section 4.1.6(1)(c) that if alterations to single elements...
-
11B-407.2.2.1 Visible and audible signals
[2010 ADA Standards] 2. In existing elevators, a signal indicating the direction of car travel shall not be required....
-
11B-407.4.6.2.1 Size and shape
[2010 ADA Standards] 407.4.6.2.1 Size. Buttons shall be ¾ inch (19 mm) minimum in their smallest dimension....
-
PRIVATE BUILDING OR FACILITY
[2010 ADA Standards 106.5] Private Building or Facility....
-
11B-407.2.1.1 Height
[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
- Wooster Products Anti-Slip Safety Coatings Systems
- AccessRec PathMat Temporary ADA Beach Access Mat
-
Clearance
The minimum width of exterior routes on public streets and sidewalks will likely be revisited in supplementary guidelines specific to public rights-of-ways that the Board intends to develop...
-
Section 1630.14(d) Other Acceptable Examinations and Inquiries
It should be noted, however, that the medical records developed in the course of such activities must be maintained in the confidential manner required by this part and must not be used...
-
Acknowledgments
For information and assistance, the author would like to thank Ellen Eubanks, San Dimas Technology and Development Center; Gina Reese, Ashley National Forest; Donna Sheehy, Northern Region...
-
§ 36.404(a)(2)(ii)
(ii) A series of buildings on a common site, connected by a common pedestrian access route above or below the ground floor, that is either under common ownership or common control or developed...
-
Sec.36.404(a)(2)(ii)
(ii) A series of buildings on a common site, connected by a common pedestrian access route above or below the ground floor, that is either under common ownership or common control or developed...
-
Workforce Investment Act of 1998
opportunity to apply for and participate in WIA-funded activities and services; it reauthorizes Rehabilitation Act programs through Fiscal Year 2003 and links them to state and local workforce development...
-
4. Summary of Practice
4.1 This practice was developed specifically for estimating pathway roughness from longitudinal profile measurements. 4.2 Longitudinal profile measurements for one wheel track are transformed...
-
The Project
“The Universal Design of Tactile Exhibits with Touch Activated Audio Description for Aquariums,” known as the “Talking Tactile Fish Project” for short, was a three-year Field Initiated Development...