Specifically, toilet buildings at developed recreation sites with only one riser must comply with the requirements for toilet room size and clearances in section 603 of ABAAS and with the...
Search Results "Latch Side Clearance"
Filters
Commonly Searched Documents
-
Toilet Buildings and Pit Toilets
-
Expert Report of Douglas J. Anderson, RAS, CASP, LCM Architects (August 8, 2018)
Voting Area: There is insufficient maneuvering clearance in front of voting station (1991 ADA Stds 4.2.3; 2010 ADA Stds 304.3)....
-
Allegion Falcon 1990 Series Cross Bar Exit Devices
It is equipped with hardened steel latches and adjustable strike to ensure safety, security and quiet operation. ...
-
Allegion Falcon SC90 Series Surface Mounted Door Control
Specifications Meets ANSI A117.1 ANSI/BHMA A156.4, Grade 3 UL Listed Closer mounts hinge side, top jamb or parallel arm when either the Rw/PA or Hw/PA arm...
-
Sargent 8700 Surface Vertical Rod Exit Device
The SARGENT 8700 Surface Vertical Rod Exit Device has two point latching (top and bottom of the door) and is adjustable through the center case....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
11B-410.1 General
Because an accessible route requires an 80 inch (2030 mm) vertical clearance, care should be taken in selecting lifts as they may not be equally suitable for use by people using wheelchairs...
-
11B-406.5.3 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding any flared sides, or the blended transition leading to the landing....
-
809.2.2 Turning Space
It is generally acceptable to use required clearances to provide wheelchair turning space....
-
Section 5 References
“Clearance Space Envelopes of Wheeled Mobility Device Users for Computer Workstations”. Proceedings of the Human Factors and Ergonomics Society Annual Meeting 2012....
-
809.2.2 Turning Space
It is generally acceptable to use required clearances to provide wheelchair turning space....
-
809.2.2 Turning Space
It is generally acceptable to use required clearances to provide wheelchair turning space....
-
M302.2 Transfer Surface
M302.2 Transfer Surface M302.2.3 Transfer Sides Proposed requirement: The transfer surface shall be located to provide options to transfer from a mobility device onto one short...
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
11B-603.2.3 Door swing
Doors shall not swing into the clear floor space or clearance required for any fixture. ...
-
Thresholds: ADA Standard Section 404.2.5
Section 404.2.5 covers the current ADA Standards for thresholds at doors.
-
11B-812.9 Surface marking
The centerline of the text shall be a maximum of 6 inches (152 mm) from the centerline of the vehicle space and its lower corner at, or lower side aligned with, the end of the vehicle space...
-
Jacknob Corp. 6150 ADA Partition Door Hardware
6150 Knob Set For 6606 Latch - ADA Polished Chrome Zamac Contains: 6140 Knob Set For 6606 (1380 & 1390) 163500 Knob Set W/Screw For 6606 Latch - ADA...
-
Allegion Falcon 1490 Series Exit Devices
latch (standard), Hex bottom latch (standard for EL), PL - Pullman bottom latch (optional), ES - electric strike top latch (optional)....
-
Pilot Rock ART Series End Accessible Recycled Plastic Picnic Table With Arched Frame
This configuration meets or exceeds current ADA guidelines for wheelchair accessibility (30" wide, 27" under table (ground to bottom of table top) and 24" total knee and toe clearances (...
-
AD Systems’ Patient Restrooms
Often, a 40” or greater clear opening is desired but having such a large door swing into a patient restroom can be very unwieldy and make other ADA clearances extremely difficult to maintain...
-
TownSteel CDC-110 Classroom Instruder Mechanical Cylindrical
SFIC Small format IC available, 6 or 7pin, Best "A" keyway Keying KD Standard, KA, MK, GMK, GGMK, Construction Available Finish US26D, US10B stocked, other upon request Function Latch...
