Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
Search Results "Change In Direction"
-
1016.6 Openings
-
§ 37.3 Origin-to-destination service
service, it must provide assistance to those passengers who need assistance beyond the curb in order to use the service unless such assistance would result in in a fundamental alteration or direct...
-
PHONE LINES DEDICATED TO TTYS
Callers using TTYs shall not be directed to leave a message in any circumstance in which callers who do not use TTYs would instead be connected to a representative....
-
1.1.7.3.1 Detached one- and two-family dwellings
Residential Code, but not both, unless the proposed structure(s) or element(s) exceed the design limitations established in the California Residential Code, and the code user is specifically directed...
-
Jean Tessmer
It is an excellent tool for laying out and placement of ADA routes, ramps, landings, random directional surfaces, and curb ramps. 1oo% compliance can be achieved when using the sliding...
-
Safe Harbor is applied element by element in existing facilities
These incremental changes were made to address technological changes that have occurred since the promulgation of the 1991 Standards, to reflect additional study by the Access Board, and...
-
Slopes and Resting Intervals for Outdoor Recreation Access Routes
Running slope is the lengthwise slope of an outdoor recreation access route, parallel to the direction of travel....
-
11B-604.5.2 Rear wall
Since there is no change to the wording of Subsection 11B-604.5.2, there is no reason to expect that OSHPD will change its interpretation. ...
-
11B-604.5.2 Rear wall
Since there is no change to the wording of Subsection 11B-604.5.2, there is no reason to expect that OSHPD will change its interpretation. ...
-
Urinal Flush Controls
This change is consistent with the ANSI A117.1‒2003 standard....
-
218 Transportation Facilities
They have been relocated without substantive change from the technical section to this section as they scope specific technical provisions....
-
§ 38.159(a)(1) General
All vehicles covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances...
- American Standard Serin 1 - Handle Monoblock Bidet Faucet
- Sargent Wall and Frame Switch Interface for Door Operators
- Harmar RPL Residential Vertical Platform Lift
- Bobrick ClassicSeries Semi-Recessed Convertible Paper Towel Dispenser/Waste Receptacle B-3942
- Sizewise SW Low Boy
- BEA Inc. MS11 Touchless Door Access (Wave to Open)
-
May an employer ask disability-related questions or require a medical examination when an employee who has been on leave for a medical condition wants to return to work?
Yes, if an employer has a reasonable belief that an employee's present ability to perform essential functions will be impaired by a medical condition or that he or she will pose a direct...
-
1016.6 Openings
Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
-
USE OF THE WAY
Once notified, people who are deaf or hard of hearing can read and follow standard exit and directional signs and use any standard means of egress from the building....
-
304.3.2 T-Shaped Space
Each arm of the T shall be clear of obstructions 12 inches (305 mm) minimum in each direction and the base shall be clear of obstructions 24 inches (610 mm) minimum....
-
Floor [1014.3]
When the floor surface is constructed of asphalt, concrete, or boards, the slope of the floor surface must be no steeper than 1:48 (2 percent) in any direction, regardless of the type of...
-
R304.2.1 Turning Space
The 1.5 m (5.0 ft) dimension shall be provided in the direction of the ramp run....