BUILT-IN ELEMENTS Dining/work surfaces 11B-226, 11B-902.2 Benches 11B-903.2...
Search Results "Transfer Surface Height"
Filters
Commonly Searched Documents
-
Built-in Elements
-
§ 38.83(b)(13) Handrails
Handrails shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less than...
-
E. M305 Supports
There were multiple significant changes made to the transfer supports section, including the addition of new requirements as well as the removal of structural strength requirements from...
-
Triax 2000
A large tripod that can be raised to a fall height above the highest play surface on a playground. ...
-
AVAILABLE DATA DO NOT SUPPORT DEPARTING FROM THE CURRENTLY ACCEPTED STANDARD OF 19-INCH TRANSFER SURFACE HEIGHT
tried to determine what the optimal accessible transfer surface height is based on available data....
-
Access-Able Designs Child Dressing Bench CH-101
height adjusts from 34-36” Available with phenolic tops or padded naugahyde that are seam-sealed to prevent penetration of bacteria and moisture....
-
Fire Rings, Grills, Fireplaces, and Woodstoves [1011.2, 1011.3, and 1011.5]
The fire-building surface within a fire ring must be at least 9 inches above the ground (figure 20)....
-
810.5.1 Slope
810.5.1 Slope. Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing...
-
810.5.1 Slope
Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...
-
11B-810.5.1 Slope
Rail platforms shall not exceed a slope of 1:48 in all directions. Exception: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...
-
810.5.1 Slope
Rail platforms shall not exceed a slope of 1:48 in all directions. EXCEPTION: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...
-
R407.6.1 Slope
R407.6.1 Slope. Landing slopes shall be 2 percent maximum in any direction.
-
R407.3 Cross Slope
R407.3 Cross Slope. The cross slope of ramp runs shall be 2 percent maximum.
-
Wayfinding is more than just graphics (slides 2 – 4)
Cognitive process (slides 2 - 4). [Wayfinding is] really more of a cognitive process. You gather information at the beginning. You cite and execute a path to take. And then you...
-
A. Slope at Door
A. If a fully automatic door is not provided, is the walkway in front of the lobby door level, without any portion steeper than 1:50 (critical dimension of ´" or less), so persons...
-
APPENDIX C
APPENDIX C On‐Site Inspection Form ETA Editor's Note Click here to download the pdf version of the document with the ON-SITE INSPECTION FORM in APPENDIX C, pdf page 41.
-
11B-810.5.1 Slope
Rail platforms shall not exceed a slope of 1:48 in all directions. Exception: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...
-
11B-810.5.1 Slope
Rail platforms shall not exceed a slope of 1:48 in all directions. Exception: Where platforms serve vehicles operating on existing track or track laid in existing roadway, the...
-
Access Board: Transfer Type Shower Compartments
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
Figure 608.5.1 Transfer Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
Staff Training
Finally, training staff to properly assist with transfers and lifts, and to use positioning aids correctly will minimize the chance of injury for both patients and staff....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
GameTime Apollo Playground Equipment Plan
Requires the Premium User plan or above. (Login or upgrade your account!) -
1015.6 Slope
The slope of the surface of clear ground spaces and turning spaces shall not be steeper than 1:48 in any direction....
