In alterations, this requirement applies where a new alarm system is installed or an existing system is replaced or upgraded; the degree of compliance is determined by the scope of work...
Search Results "Existing Physical Constraint"
-
Scoping [4.1.3(14)]
-
2. a. iii. Costs
Costs Leases should be reviewed to determine if the property owner or tenant is responsible for the cost of any ADA related changes.viii The existence of an accessible parking...
-
4.2.6 Clear Floor or Ground Space
The clear floor or ground space at fire rings, grills, fireplaces, or woodstoves may be reduced to no less than 36 inches (915 mm), where a condition for an exception in section 1.1 exists...
-
3.4.1 General
When a new viewing area is constructed, or an existing viewing area is altered or reconstructed, if a condition for exception in section 1.1 prohibits full compliance with a specific requirement...
-
2.3.1
If industry standards exist for measurement protocols, these should be referenced....
-
11B-213.3 Plumbing fixtures and accessories
The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
Subpart B -- General Requirements (Section-By-Section Analysis and Response to Comments)
These general prohibitions are patterned after the basic, general prohibitions that exist in other civil rights laws that prohibit discrimination on the basis of race, sex, color, religion...
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
2. Priority Guidelines for Removal of Access Barriers
Priority Guidelines for Removal of Access Barriers In selecting, removing, and remediating existing access barriers, the City will exercise its discretion and give priority to Pedestrian...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor when a parallel approach is provided...
-
11B-213.3 Plumbing fixtures and accessories
The 2016 California Plumbing Code (CPC), Table 422.1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
11B-608.7 Thresholds
Exception: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a ½ inch (12.7 mm) high threshold would...
-
608.7 Thresholds
EXCEPTION: A threshold 2 inches (51 mm) high maximum shall be permitted in transfer type shower compartments in existing facilities where provision of a ½ inch (13 mm) high threshold would...
-
407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1370 mm) maximum above the finish floor where a parallel approach is provided...
-
Community Resources for Independence (CRI) - Allentown, Indiana, Erie, Altoona, Bradford, Clearfield, Hermitage, Lewisburg, Lewiston, McConnellsburg, Seneca, Warren, Wellsboro, and Somerset, PA
CRI's professionally trained staff, many of whom have disabilities themselves, provide services, peer support, and referrals to existing community resources. ...
-
https://www.facebook.com/ActiveMoveNetherlands/
Active Move Netherlands is designed to encourage physical activity and support mobility improvement through structured solutions and user-friendly resources....
-
"Endless Abilities" Trailer
www.endlessabilities.org In the spring of 2012, four best friends drove across the country in search of adaptive sports for individuals with physical disabilities, and lived to tell the...
-
Number Limits
view of the matter has been strengthened by the fact that, during the 17 years since the original rule was issued, we are not aware of any instances of safety problems resulting from the existing...
-
11B-404.2.10 Door and gate surfaces
Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to provide smooth surfaces complying with 404.2.10 provided...
-
1. Program Access
redesign of equipment, reassignment of services to accessible buildings, assignment of aides to beneficiaries, home visits, delivery of services at alternate accessible sites, alteration of existing...
-
Wheelchair Accessible Gates
In addition, a modified kissing gate design was developed to be used for existing fence openings (figure 3). ...
-
405.1 General (Section-by-Section Analysis)
This proposed section closely corresponds to existing 508 Standards §§ 1194.21(k), 1194.22(j), and 1194.25(i), and is similar to § 1193.43(f) of the existing 255 Guidelines....
-
4.34.4 CONSUMER INFORMATION
To ensure that the existence of adaptable features will be known to the owner or occupant of a dwelling, the following consumer information shall be provided in each adaptable dwelling unit...
