Other than the change to clarify that the provision applies only to standing surfaces that are part of the diagnostic equipment, there have been no changes to this provision....
Search Results "Diagnostic Room"
Commonly Searched Documents
-
M304.2.1 Slip Resistant (Section-by-Section Analysis)
-
Introduction
We began our discussion by reiterating that the intent of the proposed standard is to provide for independent access to and use of diagnostic equipment....
-
F. Consultation with Food and Drug Administration
Administration has designated the Director of the Center for Devices and Radiological Health (FDA-CDRH) to consult with the Access Board on the development of standards for accessible medical diagnostic...
-
11B-809.7 Accessible routes
The accessible route shall pass through the primary entry door, through all rooms within the dwelling unit and exterior decks and balconies....
-
TRANSIENT LODGING
[DSA-AC] A building or facility containing one or more guest room(s) for sleeping that provides accommodations that are primarily short-term in nature (generally 30 days or less)....
- BEA Inc. LZR-Microscan Swinging Door Sensor
-
b. Exception for Base Support Allowance and Unobstructed Knee and Toe Space
Allowing a maximum base support height of 1.5 inches will provide room for the structural components necessary for an effective base support design and will also be accessible by around...
- Norton Surface Mounted 5600 Hands-Free Door Operation Kits
-
11B-603.5 Accessories
ETA Editor's Note The CBC 11B-603.5 limitation on the height of accessories at toilet rooms is more stringent than 2010 ADA Standards....
-
8.4 Improving Data Sources and Research
Potential benefits include: Improving diagnostic efficiency for persons with disabilities, perhaps resulting in earlier diagnosis of conditions at more treatable stages than with...
-
5.2.1 Transfer Surface Size Recommendations for M301
5.2.1 Transfer Surface Size Recommendations for M301 Description: The transfer surface is the part of the diagnostic equipment onto which patients who use mobility devices or aids transfer...
-
11B-233.3.6 Graduate student and faculty housing at a place of education
For the purposes of the application of this section, the term "sleeping room" is intended to be used interchangeably with the term "guest room" as it is used in the transient lodging standards...
-
Common Use
Interior or exterior circulation paths, rooms, spaces, or elements that are not for public use and are made available for the shared use of two or more people....
-
Public Use
Interior or exterior rooms, spaces, or elements that are made available to the public. Public use may be provided at a building or facility that is privately or publicly owned....
-
2.4.2 Considerations of Manufacturers in Accessible MDE Design
Other key factors that guide MDE manufacturers in their equipment design include: the nature of the specific diagnostic objective; safety requirements; FDA regulations (specifically 21CFR...
-
Significant alternatives
the comments submitted in response to the questions and the advisory committee’s recommendations, including alternatives that achieve the statutory objectives of ensuring that medical diagnostic...
-
13.3 Alteration
13.3 “Alteration” solely for purposes of this Consent Decree, shall mean and refer to an alteration to an accessible guest room or guest room toilet room that (1) increases or decreases...
-
11B-201.2 Application based on building or facility use
Where a site, building, facility, room, or space contains more than one use, each portion shall comply with the applicable requirements for that use....
- Access Board: Signs
-
25. RESERVATIONS SYSTEM
) until those rooms are the last non-premium rooms available....
-
11B-813.2.12 Signs
A room identification sign complying with Section 11B-216 shall be provided at entrances to adult changing facilities....
-
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302
The adjustability of medical diagnostic equipment will facilitate transfers for all types of patient populations by providing the ability to “pair” the transfer surface of diagnostic equipment...
-
M305.3 Standing Supports (Section-by-Section Analysis)
M305.3 provides the technical requirements for standing supports which are required on diagnostic equipment covered by M304....
-
5.4.3 Transfer Support Height for M301 and M302
NPRM Preamble Discussion: The Access Board is considering whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic...