Such measures include, for example, providing a ramp with a steeper slope or widening a doorway to a narrower width than that mandated by the alterations requirements....
Search Results "Compartment Width"
-
§ 36.304(d)(3)
-
Inclined Wheelchair Lifts
Codes generally prohibit inclined lifts from reducing the required width of egress routes. The ASME standard allows inclined lifts with enclosures and those without....
-
9.4 POST OFFICE BOXES
Aisles between post office boxes shall be a minimum of 66 in (1675 mm) clear width....
-
1015.3 Viewing Space
The viewing space shall be 32 inches (815 mm) maximum and 51 inches (1295 mm) minimum high above the ground and shall extend the full width of the clear ground space....
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
5.2.1.4 Transfer Surface Size for Imaging Equipment
The width of the patient scanning/imaging table (side to side) at the designated transfer location should be 28 inches minimum or the maximum extent technically feasible, but in all cases...
-
5.2.2 Transfer Surface Size Recommendations for M302
The transfer surface size has two components: width and depth. (See Figure 5.2.1.1) NPRM Proposed Provision: M302.2.2 Size....
-
18.1 Q. Is it necessary to provide usable doors when the door leads to an area of the dwelling that is not accessible, such as the door leading down to an unfinished basement...?
Such doors would have to provide at least 32 inches nominal clear width when the door is open 90 degrees, measured between the face of the door and the stop....
-
D. Entering the Emergency Shelter
An accessible entrance must provide at least one accessible door with maneuvering space, accessible hardware, and enough clear width to allow people who use crutches, a cane, walker, scooter...
-
Character Proportion [4.30.2]
Consider uniform stroke widths which can make signs easier to read....
-
Doors and Gates in Series [§404.2.6]
Doors and Gates in Series [§404.2.6] At hinged or pivoted doors or gates in series, a separation is required that is at least 48” plus the width of doors or gates swinging into the space...
-
Doors and Gates Operated Only By Security Personnel [§404.1, Ex]
If automated, such doors or gates are required to comply only with provisions for clear width and thresholds, as well as applicable provisions of the referenced ANSI/BHMA Standards....
-
§ 38.23(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch in width....
-
11B-206.2.19 Pedestrian street crossings
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
Section A: Parking
(§§502.2, 502.3) Width of space _____ Width of access aisle _____ A3 For van accessible spaces (particularly in a garage or parking structure), is...
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
3.3.2 Experienced Clinicians
The Committee is considering two main options: minimum widths of 28” or 30”. “Tables” are equipment used by patients in supine, prone, or side-lying positions....
-
Rubbermaid 7818-88 Horizontal Baby Changing Station
cm Height: 4.0 in 10.2 cm Carton Length: 33.9 in 86.2 cm Carton Width...
-
Inpro Corporation JointMaster® 316 Series Single Sightline for Carpet Floor Expansion Joint Covers
Features & Benefits System reduces joint widths of up to 4" (100mm) down to a narrow sightline of only 1" (25mm) Specially designed for continuous flooring types such...
