Interior signage shall be located alongside the door on the latch side and shall be mounted at a height of between 54 in and 66 in (1370 mm and 1675 mm) above the finished floor.
Search Results "Elevator Car Designation"
Filters
Commonly Searched Documents
-
4.30.6 MOUNTING LOCATION AND HEIGHT
-
4.30 SIGNAGE
[See subsections ...]
-
A.4.30 SIGNAGE
[See subsections ...]
-
11B-216 Signs.
[See subsections ...]
-
C. Americans with Disabilities Act and Section 504 of the Rehabilitation Act
The Americans with Disabilities Act (ADA) and Section 504 of the Rehabilitation Act are civil rights laws that prohibit discrimination on the basis of disability. Title II of the ADA...
-
11B-703 Signs
11B-703 Signs.
-
11B-216 Signs
[See subsections ...]
-
11B-703 Signs
[See subsections ...]
-
Social Security Administration Guide: Alternate Text for Images
Trademarks Many designations used by manufacturers and sellers to distinguish their products are claimed as trademarks....
-
1007.8 Two-way communication
A two-way communication system shall be provided at the elevator landing on each accessible floor that is one or more stories above or below the story of exit discharge complying with Sections...
-
Typical Day One - Basic Facilities Requirements
(30 minutes) This section will give you an overview of the Law including effective dates, regulations, design standards, enforcement and exemptions....
-
11B-233.3.1.2.5 Multi-story residential dwelling units in buildings with no elevator
In non-elevator buildings, a minimum of 10 percent but not less than one of the ground floor multi-story residential dwelling units shall be calculated using the total number of multi-story...
-
Accessibility Professionals Association (APA)
Accessibility Standards (TAS), and other current and upcoming accessibility codes and standards for any accessibility specialists, Registered Accessibility Specialists (RAS), architects, designers...
-
4.10.14* EMERGENCY COMMUNICATIONS
If provided, emergency two-way communication systems between the elevator and a point outside the hoistway shall comply with ANSI A17.1-1978 and A17.1a-1979....
-
Tactile Design for Universal Access
Touch Graphics, Inc. was established in 1997 to refine and commercialize methods for tactile graphics production that were first demonstrated by Karen Luxton Gourgey and the Computer...
-
DO-IT Center
Promote the application of universal design to physical spaces, information technology, instruction, and services....
-
Section 37.42
Section 37.42(e) provides a safety requirement concerning the setback of structures and obstacles (e.g., mini-high platforms, elevators, escalators, and stairwells) from the platform edge...
-
Access CommunicationsTM Consulting Services
Everyone should be using these new rules, called the 2010 ADA Standards for Accessible Design. ...
-
Line Spacing: ADA Standard Section 703.5.9
Spacing between the baselines of separate lines of characters within a message shall be 135 percent minimum and 170 percent maximum of the character height.
-
11B-703.5.9 Line spacing
Spacing between the baselines of separate lines of characters within a message shall be 135 percent minimum and 170 percent maximum of the character height.
-
REFERENCES
2, California Building Code, Sections 11B-202.4 This Interpretation of Regulations (IR) is intended for use by the Division of the State Architect (DSA) staff, and as a resource for design...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides, elevators...
-
402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides, elevators...
