This proposed section is consistent with 255 Guidelines §1193.41....
Search Results "Design Guideline"
Filters
Commonly Searched Documents
-
C202.1 General (Section-by-Section Analysis)
-
602.4 Alternate Formats for Non-Electronic Support Documentation (Section-by-Section Analysis)
This proposed requirement is taken from §§ 1194.41(a) and 1193.33(a)(2) of the existing 508 Standards and 255 Guidelines, respectively, with minor editorial changes....
-
410.6.4 Voice Mail, Auto-Attendant, and IVR Compatibility (Section-by-Section Analysis)
This section derives from existing 508 Standards §§ 1194.23(c)-(e), as well as existing 255 Guidelines §§ 1193.51(d)-(e)....
-
1014.2.2 Roll-in Access
The section also requires a turning space complying with 304.3 of the Architectural Barriers Act Accessibility Guidelines to be provided within the camp shelter....
-
7.2.2.2 Extent of Impracticability
Exception 2 permits exemption of an entire trail from the requirements of section 7.4.1 through 7.4.8, it may be beneficial to construct a portion of the trail to meet the trail accessibility guidelines...
-
X. Alterations
The architectural standards for accessibility in alterations are contained in the ADA Accessibility Guidelines issued by the Architectural and Transportation Barriers Compliance Board....
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The Committee based this recommendation on related provisions in the 2004 ADA and ABA Accessibility Guidelines for handrails and grab bars....
-
Detectable Warning Surfaces at Shared Use Path Intersections
The proposed accessibility guidelines for pedestrian facilities in the public right-of-way would require the use of detectable warning surfaces to indicate the boundary between a pedestrian...
-
407.3.1 Identification (Section-by-Section Analysis)
This section is new to the 255 Guidelines, but is similar to existing 508 Standards §§ 1194.23(k)(1), 1194.25(c), and 1194.26(b)....
-
Employee Work Areas: ADA Standard Section 203.9
Section 203.9 covers scoping requirements of general exceptions for employee work areas in the most current ADA Standards.
-
11B-222.1 General
Different styles of design provide users varying levels of privacy and convenience....
-
American National Standard/AAMI HE75:2009/(R)2013 Human factors engineering – Design of medical devices
It is most important that the objectives and potential uses of an AAMI product standard or recommended practice are clearly understood. The objectives of AAMI's technical development...
-
Minimum Number: ADA Standard Section 234.4.2
Section 234.4.2 covers the most current ADA scoping requirements for the minimum number of wheelchairs spaces, transfer seats or devices at existing amusement rides.
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved....
-
11B-1005.3 Edge protection
Extending the deck of the fishing pier or platform 12 inches (305 mm) where the 34 inch (865 mm) high railing is provided is an alternative design, permitting individuals using wheelchairs...
-
11B-1009.2.4 Seat
The height of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the...
-
Readily achievable (Advisory Guidance)
Depending on the design, technology, or several other factors, it may be determined that providing accessibility to all products in a product line is not readily achievable....
-
B. Technical standards for criterion-related validity studies
length of time on the job where time on the job is likely to affect performance, and other relevant factors likely to affect validity differences; or that these factors are included in the design...
-
References
References "Guidelines for Reporting and Writing About People with Disabilities," produced by the Research and Training Center on Independent Living, University of Kansas....
-
R406 Reach Ranges (Section-by-Section Analysis)
The requirements for reach ranges differ from the 2004 ADA and ABA Accessibility Guidelines in that forward reach over an obstruction is not permitted, and side reach over an obstruction...
-
407.3.3 Numeric Keys (Section-by-Section Analysis)
The requirement for a tactilely discernible “5” key derives from existing 508 Standards § 1194.23(k)(1), but would be a new requirement for the 508 Standards and 255 Guidelines....
-
A4.26.1 General
The grab bar clearance of 1‒1/2 in (38 mm) required in this guideline is a safety clearance to prevent injuries resulting from arms slipping through the openings....
-
Protruding Object
Accessibility guidelines for protruding objects do not apply to naturally occurring objects, such as tree branches, or rock ledges....
-
Dwelling Unit
For purposes of these guidelines, use of the term “Dwelling Unit” does not imply the unit is used as a residence....
