Section 4.1.6(3) recognizes certain allowances where technical feasibility is encountered, such as steeper slopes for short ramps....
Search Results "Parking Slope"
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
-
4.13.8* THRESHOLDS AT DOORWAYS
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
11B-608.9 Shower floor or ground surface
Floor or ground surfaces of showers shall comply with Section 11B-302.1 and shall be sloped 1:48 maximum in any direction....
-
1016.4 Passing Spaces
Where passing spaces and resting intervals overlap, the technical requirements for resting intervals in 1016.8.3 require the slope of the surface to not be steeper than 1:48 in any direction...
-
Applying the Accessibility Standards to the Plan, Installation, and Maintenance of Ground Level Accessible Routes for Playgrounds
Is the running slope for the ground level accessible route less than 1:16 or 6.25%? Is the maximum cross slope for the ground level accessible route less than 1:48 or 2.08%?...
- Forms + Surfaces Summit Bike Rack
-
§35.190(b)(5)
(5) Department of Interior: all programs, services, and regulatory activities relating to lands and natural resources, including parks and recreation, water and waste management, environmental...
-
Introduction
For example, when a curb ramp extends into an access aisle at an accessible parking space, a person using a wheelchair may not be able to get out of the car or van....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. Figure 1009.2.2 Pool Lift Seat Location...
-
A1
Is a relatively level (1:50 or 2% maximum slope in all directions) access aisle provided adjacent and parallel to the side of the vehicle pull-up area?...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
M303.3.3.1 Running Slope. Ramp runs shall have a running slope no steeper than 1:12. M303.3.3.4 Edge Protection....
-
Boarding Piers at Boat Launch Ramps
A boat launch ramp is a sloped surface designed for launching and retrieving trailered boats and other watercraft to and from a body of water....
-
Camping Unit
A discrete area within a campground with a persons at one time capacity (PAOT) of 5 that usually includes a camp living area, a parking spur, and one or more constructed features such as...
-
III-7.5130 Entrances
In addition, there must be accessible entrances to enclosed parking, pedestrian tunnels, and elevated walkways....
-
When is a Curb Ramp a Ramp?
[DSA-AC] A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face. 1991 &...
- UMEA Waste Receptacle
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. FIGURE 11B-1009.2.2 POOL LIFT SEAT LOCATION...
-
R409.10.3 Bottom Extension at Stairways
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
§ 38.23(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
-
B3. Access Aisle
[ADA Stds 4.6.6] Note: Unlike an accessible parking space, the surface for the access aisle does not have to be marked or striped. Yes _____ No _____...
-
4.6.6 VERTICAL CLEARANCE
If accessible van parking spaces are provided, then the minimum vertical clearance should be 114 in....