Amusement Rides with Wheelchair Spaces Minimum space requirements and clearances for wheelchairs are specified where a ride provides a wheelchair space....
Search Results "Lavatory Clear Floor Space"
Commonly Searched Documents
-
Amusement Rides with Wheelchair Spaces
- Aluminum Flush Top SGF Series Pressure-Locked Grating
-
R309.2 Parallel Parking Spaces
R309.2 Parallel Parking Spaces. Parallel parking spaces shall comply with R309.2. Advisory R309.2 Parallel Parking Spaces....
-
R407.9.1 Extended Ramp Surface
R407.9.1 Extended Ramp Surface. The surface of the ramp run or landing shall extend 305 mm (1.0 ft) minimum beyond the inside face of a handrail complying with R409. Advisory...
- Figure 302.3 Elongated Openings in Floor or Ground Surfaces – Drawing from the U.S. Access Board
-
3.13(d) Number of Wheelchair Spaces Required
Number of Wheelchair Spaces Required: Cinemark shall provide at least the minimum number of wheelchair spaces required in each auditorium as set forth in § 4.1.3(19)(a) of the Standards...
-
3. Measuring Door Openings
Measuring Door Openings Special care is needed when measuring the clear opening of a doorway. To measure the clear opening of a standard hinged door, open the door to 90 degrees....
-
11B-304.3.2 T-Shaped space
The turning space shall be a T-shaped space within a 60 inch (1524 mm) square minimum with arms and base 36 inches (914 mm) wide minimum....
-
11B-206.4.1 Entrances
All entrances shall comply with Section 11B-404. [2010 ADA Standards] 206.4.1 Public Entrances. In addition to entrances required by 206.4.2 through 206.4.9, at least 60 percent...
-
C. Doors
Doors - Examine each of the interior routes described above: ...with the exception of doors at shallow closets, do the doors to required accessible spaces, and all doors into and within...
-
11B-812.6 Vehicle spaces
All vehicle spaces shall be marked to define their width....
-
Figure 11B-407.2.3.1 Floor designation
SECTION TITLE NOTES Figure 11B-407.2.3.1 Floor designation....
-
4.34.5.5 SHOWERS
If a shower is provided, it shall have the following features:
-
11B-302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
11B-302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
11B-302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with Section 11B-303....
-
11B-221.3 Companion seats
At least one companion seat complying with Section 11B-802.3 shall be provided immediately adjacent to each wheelchair space required by Section 11B-221.2.1....
-
Van Space: Wider Parking Space
Van Space: Wider Parking Space Recommendation: Sizing all accessible spaces (or access aisles) for van accessibility provides greater convenience and helps ensure that van...
-
11B-304.3.2 T-Shaped space
The turning space shall be a T-shaped space within a 60 inch (1524 mm) square minimum with arms and base 36 inches (914 mm) wide minimum....
-
11B-304.3.2 T-Shaped space
The turning space shall be a T-shaped space within a 60 inch (1524 mm) square minimum with arms and base 36 inches (914 mm) wide minimum....
-
Wheelchair Storage Space
There must be space in or adjacent to load and unload areas for each ride seat designed for transfer or transfer device. The space must be a minimum of 30 inches by 48 inches....
-
4.5.3* Carpet
If carpet or carpet tile is used on a ground or floor surface, then it shall be securely attached; have a firm cushion, pad, or backing, or no cushion or pad; and have a level loop, textured...
-
7.3(2)
(2) Clear aisle width for accessible check-out aisles shall comply with 4.2.1 and maximum adjoining counter height shall not exceed 38 in (965 mm) above the finish floor....
- Symmons Ultra-Sense Battery Powered Sensor Faucet S-6060