Section 218.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for transportation facilities.
Search Results "Bus Stop"
Filters
Commonly Searched Documents
-
General: ADA Standard Section 218.1
-
Transportation Facilities: ADA Standard Section 218
Section 218 covers scoping requirements in the current ADA Standards for transportation facilities.
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
11B-218 Transportation facilities
[See subsections ...]
-
T205.1 General
Non-rail vehicles shall provide illumination complying with T503 at ramps, bridgeplates, doorways, and boarding and alighting areas.
-
T404.3 Ramps and Bridgeplates
Where the space between the floor of non-rail vehicles and a boarding platform is greater than 2 inches (51 mm) horizontally or 5/8 inch (16 mm) vertically when measured at 50...
-
T204.2 Doorways with Lifts, Ramps or Bridgeplates
Doorways with lifts or ramps shall comply with T502.2.
-
§ 38.33 Fare box
Where provided, the fare box shall be located as far forward as practicable and shall not obstruct traffic in the vestibule, especially wheelchairs or mobility aids.
-
Section 37.169 Interim Requirements for Over-the-Road Bus Service Operated by Private Entities
Section 37.169 Interim Requirements for Over-the-Road Bus Service Operated by Private Entities Private over-the-road bus (OTRB) service is, first of all, subject to all the other private...
-
BraunAbility Century 2 Wheelchair Lift for School Buses, Cutaway Buses, and Paratransit Vans
The simplified electrical system offers trouble-free operation, while the non-hydraulic spring-loaded roll stop keeps the wheelchair securely on the wheelchair lift platform throughout the...
-
T704.2.2 Operation
A mechanism for requesting stops shall be located at each wheelchair space and priority seat for passengers with disabilities....
-
T207.2 Passenger Doorways
Handrails or stanchions shall be provided at passenger doorways in a configuration that permits grasping and use from outside the non-rail vehicle and throughout the boarding and...
-
T204.3 Doorways with Level Boarding and Alighting
Doorways with level boarding and alighting shall comply with T502.3.
-
T402.9 Transitions
Vertical surface discontinuities at transitions from boarding and alighting areas to ramps and bridgeplates shall comply with T302.4.
-
11B-411.4.7.3 Symbols
The control button for the emergency stop, alarm, door open, door close, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3....
-
11B-411.4.7.3 Symbols
The control button for the emergency stop, alarm, door open, door close, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3....
-
11B-411.4.7.3 Symbols
The control button for the emergency stop, alarm, door open, door close, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3....
-
R208.1 Where Required
Detectable warning surfaces complying with R305 shall be provided at the following locations on pedestrian access routes and at transit stops: 1....
-
Costs and Benefits
requirement, the Final RA models costs using three prototypical size-based categories—which are denominated Tiers I, II and III—that are intended to be representative of the range of fixed route bus...
-
Level boarding
If not using a lift or ramp to provide level boarding, the grantee must submit to FTA a demonstration of equivalent facilitation. (DOT ADA Regulation 49 C.F.R. 37.7(b) and DOT ADA...
-
Door stop
[See subsections ...]
-
T204.1 General
Doorways on non-rail vehicles shall comply with T204.
-
T210.4 Location
Wheelchair spaces shall be located as near as practicable to doorways that provide a means of accessible boarding and alighting.
-
T204 Doorways
[See subsections ...]
