Hello. Please sign in!

Note: This document or portion of document references a state or local code that is stricter than the 2010 ADA Standards requires.

11B-405.9.2 Curb or barrier.

A curb, 2 inches (51 mm) high minimum, or barrier shall be provided that prevents the passage of a 4 inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102 mm) of the finish floor or ground surface. To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp.

An elevation drawing shows a vertical clearance of less than 4 inches between the ramp surface and the bottom edge of a horizontal rail.

FIGURE 11B-405.9.2 ‡‡
CURB OR BARRIER EDGE PROTECTION

ETA Editor's Note

CBC requires either a curb or a barrier for edge protection at ramps, and does not recognize the extended floor or ground surface also permitted by 2010 ADAS.

[MORE INFO...]

*You must sign in to view [MORE INFO...]